Numerical simulation of solidification zone in twin-roll thin strip continuous casting process

PAN Liping,LI Baokuan,HE Zhu
2014-01-01
Abstract:A mathematical model of solidification zone in twin-roll thin strip continuous casting process was established by numerical simulation method.The solidification endpoint position under working conditions of twin-roll thin strip continuous caster of a certain pre-production equipment was calculated.At the same time,the factors that affected the solidification end-point such as pouring temperature,roll speed and other process parameters were analyzed.The results showed that when the outflow direction of molten steel was moved 2mm in right and left side in design and the casting speed was 30m/min,the distribution of solidification zone was the best;The rising of pouring temperature had little effect on the solidification end-point position;When the roller speed increased,the longitudinal position of the solidification end-point would gradually reduce and disappear.
What problem does this paper attempt to address?