Abstract:The heat transfer of a slab is significantly influenced by roll contact during the continuous casting process. The influence of roll contact calculation methods on the predicted heat transfer results has not been previously investigated. In this work, the non-uniform solidification of the wide-thick slab was studied with a 2D heat transfer model using real roll contact method (R. method) and equivalent roll contact method (E. method). The predicted slab surface temperature and shell thickness were verified with the measured results of the infrared camera and nail shooting experiments, respectively. Then, the predicted heat transfer results (including the slab surface temperature, mushy region length, and solidification end position) for the wide-thick slab with different thicknesses and different casting speeds were calculated using the E. method and R. method, and the influence of these two roll contact methods on the predicted heat transfer results was discussed for the first time. The results show that both these two roll contact methods could be applied to accurately predict the slab surface temperature without considering the transient temperature dips in the roll–slab contact regions. However, the deviation of the predicted mushy region length and solidification end position using the E. method are obvious. Compared with the R. method, the predicted mushy region length obtained using the E. method is larger and the solidification end obviously subsequently moves along the casting direction.

Research methods and influencing factors of interfacial heat transfer during sub-rapid solidification process of strip casting

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Research Progress of Transient Interfacial Heat Transfer During Sub-Rapid Solidification Process

Mathematical Heat Transfer Model Research for the Improvement of Continuous Casting Slab Temperature

Effect of Coating on Instantaneous Interfacial Heat Transfer During Near-Rapid Solidification

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Simulation of Subrapid Solidification and Secondary Cooling for the Strip Casting of IF Steel

Effect of Coating of Continuous Casting Crystallization Roller on Heat Transfer and Solidification Structure

Experimental Investigation of Interfacial Thermal Conductance for Molten Metal Solidification on A Substrate

Investigation of Solidification Heat Transfer in Slab Continuous Casting Process Based on Different Roll Contact Calculation Methods

Experimental Study on Heat Transfer Boundary Conditions for Steel Hot Extrusion Process

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

Heat transfer behavior and formation mechanism of stainless steel cladding carbon steel plate during horizontal continuous liquid-solid composite casting

Determination of Interfacial Heat Flux of Stainless Steel Solidification on Copper Substrate During the First 0.2 S

Applying of Real-time Heat Transfer and Solidification Model on the Dynamic Control System of Billet Continuous Casting

A Study of the Interfacial Heat Transfer Between an Iron Casting and A Metallic Mould

Laboratory Experimental Setup And Research On Heat Transfer Characteristics During Secondary Cooling In Continuous Casting

Investigation of Solidification, Heat Transfer and Fluid Flow in Continuous Casting of Steel Using an Advanced Modeling Approach

Heat Transfer Simulation for Covers in Continuous Casting Process of Steel and Its Application