Abstract:Taking horizontal twin-roll casting mill as the research object, the geometric modeling and gridding of the rolling mill are completed by using the design modeler and gridding module of ANSYS Wrkbench platform. Combined with Fluent fluid simulation module, a two-dimensional steady-state laminar flow coupled model of copper-aluminium clad plate cast-rolling process was established. Through the analysis of range data obtained by orthogonal simulation design method, the order of importance of each factor is as follows: billet speed, cast-rolling zone length, preheating temperature of copper strip, pouring temperature. Through the analysis of factors and indicators (liquid hole depth ratio), the suitable technological parameters range are 0.3~0.6 m.min-1 for billet speed, 933~993 K for pouring temperature, 300~431 K for preheating temperature of copper strip, 57~80 mm for cast-rolling zone length. In order to verify the reliability of numerical simulation method and result analysis, the casting-rolling test was carried out with simulated process parameters. The exit temperature was measured by thermocouple. The results show that the error between simulation results and measured results is small, which verifies the accuracy of simulation and the feasibility of guiding production. When the billet speed is 0.5 m/min, the pouring temperature is 963 K, the length of casting-rolling zone is 70 mm and the copper strip is not preheated, the 10 mm thick copper-aluminium composite plate has better shape. The tensile properties show that the composite plate has both the high plasticity of aluminium and the high strength of copper.

Numerical Simulation of Solidification Process in an SCR Wheel and Belt Continuous Caster

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Numerical Simulation of Influence of Vertical Continuous Casting Process Parameters on Heat Transfer and Mold Stress of C71500 Large Diameter Hollow Ingot

Application of Process Simulation Software on Secondary Cooling Optimization for Continuous Caster

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

An Experimental and Numerical Study on the Modelling of Fluid Flow, Heat Transfer and Solidification in a Copper Continuous Strip Casting Process

Computational modeling and control system of continuous casting process

Numerical Simulation of Solidification and Heat Transfer in Continuously Cast Bloom

Numerical modeling and simulation of water cooling-controlled solidification for aluminum alloy investment casting

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Simulation Study on Horizontal Continuous Casting Process of Copper Hollow Billet under Rotating Electromagnetic Stirring Part 2—effects of Electromagnetic and Casting Parameters on Solidification Process

Numerical Simulation And Optimization Of Directional Solidification Process Of Single Crystal Superalloy Casting

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Numerical Study On Solidification Behavior And Structure Of Continuously Cast U71mn Steel

Simulation of Temperature Field and Microstructure in Heavy Steel Ingots Solidification

Numerical Simulation and Experimental Casting of Nickel-Based Single-Crystal Superalloys by HRS and LMC Directional Solidification Processes

Mould Taper Optimization for Continuous Casting Steels by Numerical Simulation

Numerical Analysis for Position and Shape of Solid-Liquid Interface during Continuous Casting of Single Crystal Cu

Numerical simulation of coupled fluid flow and solidification in a curved round bloom continuous caster with a combined rotary electromagnetic stirring

Numerical Simulation of Macrosegregation Impurities in the Solidifying Continuous Casting Steel Billet