Abstract:This study presents an adaptive algorithm for distance relays. In this algorithm, the network connected to the transmission line terminals are modelled using an equivalent circuit, and the impedances of this equivalent circuit are estimated. By employing this algorithm, relay errors (over/under reach) caused by changes in network structure, the presence of fault resistance, and injected current from the remote end of the transmission line are eliminated. As a result, the relay accurately determines fault location and fault resistance, enhancing the performance of its Zone1 and Zone2 functions. Faults in power systems occur for various reasons, such as aging or natural disasters. Detecting, locating, and promptly clearing these faults is crucial for maintaining the safety and reliability of transmission lines (TLs). Distance relays (DRs), which protect TLs, detect faults, estimate their location, and send the required commands. However, these relays may experience mis‐detection due to manipulated impedance arising from both internal and external factors. These factors include measurement device errors, network topology changes, the presence of fault resistance (FR), and injected currents from remote line terminals. To address this challenge, an innovative adaptive protection scheme that considers FR, changes in network topology, and injected current from the opposite end of the line is proposed. By estimating the equivalent circuit impedances (ECIs) of the network connected to the terminal of the TL, this protection scheme utilizes impedance estimation techniques at the line terminals and offline network information. Simulation studies (tested on the IEEE 39‐bus standard network) show that the proposed scheme accurately estimates fault location (FL) and FR with high precision. The simulation results demonstrate its effectiveness in improving the performance of conventional distance protection relays in both the first and second protection zones (Zone1 and Zone2 ).

UNIFIED EXPRESSION OF FAULT-COMPONENT DISTANCE RELAY

Adaptive Distance Relay for Preventing Error Action of Reactive Fault

New Type Adaptive Distance Relay with Improved Performance

A fault-component based adaptive distance protection scheme

Error Analysis of Distance Relay Protection in Phase-to-Phase Short Circuit Fault

ULTRA HIGH SPEED DIRECTION RELAY BASED ON FAULT TRANSIENT ENERGY——PRINCIPLE

NOISE EVALUATION BASED ADAPTIVE FAST DISTANCE RELAY PROTECTION

An Improved Fault Phase Selector for Transmission Line Protective Relay

Distance Relaying of Asymmetrical Double-Circuit Transmission Lines Considering Abnormal Faults

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

A Simplified Method of Distance Relay Zone-Ⅱ Setting Calculation and a Region-based Backup Relaying Scheme

Performance analysis of multiphase compensated distance relay in single-phase-to-ground fault with power swing

Improved Setting Method of Distance Protection with the SSFCL

An Adaptive Backup Distance Relaying Scheme Based on Communication Between Neighboring Substations

Performance analysis of phase distance relay on series compensated UHV lines

Distance Protection That Insensitive to Power Swing

An adaptive distance protection scheme considering fault resistance, injected current, and structural changes in the power system

Distance Protection Principle for Series Compensated Lines Based on the Impedance Angle of the Compensated Point

Study on Software of Relay Settings Examination and Rectification

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Fast distance protection based on real-time estimation of transient main frequency