Abstract:In recent years, with the rapid development of tiny electronic components. At present, commonly used optical inspection technology and electron microscope inspection technology find it difficult to meet the dimensional inspection requirements of key components of highly integrated integrated circuits. Based on computer micro-vision technology, the coupling of measuring platform displacement to the development of miniature electronic components is of great significance for the analysis and design of precision platforms. This paper analyzes the influence of the three factors of material, software and environment on the accuracy positioning of the measurement system. The analysis shows that the characteristics of the imaging system itself and the image noise it brings are the main factors that affect the measurement accuracy. In this paper, a technique for blindly detecting the position of the scanner based on computer vision is proposed. This article uses a CCD optical camera to capture the orbital motion of the electronic pen, and uses video image processing algorithms, computer vision and position to capture the position of the light on the screen. With the support of specific software, this article creates a new interactive whiteboard system. Any large screen can be turned into a large touch screen with electronic writing surface and touch function. The device does not require a specific additional screen to operate, and the cost is lower. In this paper, the stereo microscope has a narrow field of view, small depth of field and many non-linear factors. Based on the analysis of existing camera models, a binocular microscope imaging model based on a linear camera is established. On this basis, through the experimental analysis of the feasibility of the existing camera calibration method in the binocular microsystem, the calibration method of the camera's main parameters is proposed. Experiments show that the resolution value of the peak value of the evaluation curve in this paper is 18 times the focus resolution value, while the commonly used algorithm for evaluating the peak value of the curve is only 14 times. Compared with the latter, the discrimination of the edge gradient Laplacian used in this paper is more obvious than the former.

Study of Dynamic Measurement Technology Used Monocular Micro-Vision Probe

Dynamic Confocal Optical Probe Based on Time Difference Measurement

Study on dynamic measurement uncertainty evaluation for CMMs

Study of Stereo Vision Coordinate Measurement System Based on Optical Probe

Dynamic Error Modeling and Compensation of a Scanning Probe on CMM

Uncertainty Evaluation Study of CMM Dynamic Measurement Based on Quasi Monte Carlo Method

Application Of Computer Microvision And Microscopic Interferometry In Measurement System For Three-Dimensional Static And Dynamic Characterization Of Mems

Characterization Of Dynamic Microgyroscopes By Use Of Temporal Digital Image Correlation

Multi-point dynamic displacement probe that uses a self-focusing micro-lens array

MEMS Dynamic Testing System and Data Processing

Study on the measuring system of the planar parallel micro-motion worktable's location and orientation

Flexible Dynamic Measurement Method of Three-Dimensional Surface Profilometry Based on Multiple Vision Sensors

Measurement System For Mems Dynamics Characterization With Environmental Control Facility

Dimension Measurement Based on MEMS Micro Tactile Probe and Nanomeasuring Machine

800× Non-Distortion Magnified Visualization of Deep Sub-Nanometer MEMS Vibrations Using a Camera

Microscopic Vision Based on the Adaptive Positioning of the Camera Coordinate Frame

&Lt;title>ccd-Based Microscopic Measurement System for Precision Part Geometry Error</title>

Measuring Three-Dimensional Micro-Motions of Microstructures Using Optical Sectioning

Dynamic Length Measuring System for Large Scale Workpieces

Monocular Computer Vision Measurement System

Positioning Technology of Tiny Electronic Components Based on Microscope and Computer Vision