Abstract:When the microprobe sensor is faced with the demand of high-speed biaxial displacement measurement, due to the characteristics of phase generated carrier (PGC) technology, accompanying optical intensity modulation (AOIM) and unfavorable phase modulation depth (PMD) will bring about the tens of nanometer cyclic nonlinear errors, further hindering high-speed and high-precision measurement. Herein, a light source intensity stabilization system based on semiconductor optical amplifier (SOA) feedback control is achieved to eliminate the error caused by AOIM in the presence of high-frequency and large-amplitude laser modulation. Based on this, the reasons for large nonlinear errors in biaxial measurements and the inability to ensure the stability of the accuracy of multiple measurement axes are methodically examined, and an effective nonlinear error elimination methodology based on the normalized amplitude correction of active temperature scanning is proposed. The continuity and linearity of the temperature scanning are also discussed. The performed experiments show that the above approach is capable of reducing the displacement demodulation error from the nanometer scale to the sub-nanometer scale. Further, the nonlinear error is reduced to within 0.1 nm for both measurement axes and the performance becomes consistent. The dual-axis measurement resolution of the microprobe sensor reaches 0.4 nm and the measurement speed is better than 1.2 m/s with the standard deviation of lower than 0.5 nm.

Dynamic Confocal Optical Probe Based on Time Difference Measurement

A High-Precision Five-Degree-Of-Freedom Measurement System Based on Laser Collimator and Interferometry Techniques

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

A Novel Method to Simultaneously Measure the Straightness

High-precision laser alignment technique based on spiral phase plate

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

A Chromatic Confocal Probe with a Mode-Locked Femtosecond Laser Source

Stability research of laser confocal probe for measuring the micro-shpere

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

Differential Confocal Optical Probes with Optimized Detection Efficiency and Pearson Correlation Coefficient Strategy Based on the Peak-Clustering Algorithm

Dynamic Error Modeling and Compensation of a Scanning Probe on CMM

A New Centering Method of the Measuring Probe for Spiral Scanning-Based Surface Profile Measurement Systems

A Fiber-Based Chromatic Dispersion Probe for Simultaneous Measurement of Dual-Axis Absolute and Relative Displacement

Multi-point dynamic displacement probe that uses a self-focusing micro-lens array

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Development of a High-Precision Multifunctional Probe for Measuring Microstructures

Chromatic Confocal Displacement Sensor with Optimized Dispersion Probe and Modified Centroid Peak Extraction Algorithm.

High-speed and high-precision measurement of biaxial in-plane displacements: tens of nanometers principle error suppression in microprobe sensors

Distance Measurement for Curved Surface Based on Confocal Technique

Error identification and compensation for a laser displacement sensor based on on-machine measurement