Abstract:This article describes an ultra-high input-impedance active electrode (AE) circuit and the system to sense biopotential signals through a capacitively coupled interface. Various techniques from both circuit and system aspects are used to eliminate the input parasitic capacitance of the AE. On-chip parasitic capacitance is compensated by an auto-calibrated positive feedback loop (PFL) without applying any reference signal. A capacitor down-scaling technique combined with SAR-assisted PFL calibration enables femtofarad-level resolution of the capacitor array, alleviating the practical constraints of the conventional PFL to implement a small capacitor below 10 fF. Besides, a dummy input structure ensures that the pad and electrostatic discharge (ESD) capacitances are also canceled by the PFL, while off-chip parasitic capacitance on the printed circuit board (PCB) is nulled by active shielding. Fabricated in a standard 0.18- $\mu$ m 1P6M CMOS process, the AE achieves an ultra-high input impedance of 136 G $\Omega$ at 60 Hz (average of 10 samples). This is equivalent to an input capacitance of 19.5 fF and corresponds to a 2.7 $\times$ –68 $\times$ improvement over the state-of-the-art. The AE exhibits an input signal range of 700 mV $_{\mathrm{pp}}$ and an input-referred noise of 0.72 $\mu $ V $_{\mathrm{rms}}$ (0.5–100 Hz) while consuming 10.46 $\mu $ W from a 1.2-V supply. Each AE integrates an IC and a 3-cm $^{2}$ copper electrode on the PCB, and the wearable system prototypes successfully measured high-quality electrocardiogram (ECG) and electroencephalogram (EEG) signals from test subjects through capacitively coupled interfaces.

A 400 GΩ Input-Impedance Active Electrode for Non-Contact Capacitively Coupled ECG Acquisition with Large Linear-Input-Range and High CM-Interference-Tolerance

A 136G-Input-Impedance Active Electrode for Non-Contact ECG Using Auto-Calibrated. Positive Feedback and Capacitance Scaling in Femtofarad Resolution

Evaluation Of Non-Contact Flexible Electrodes Connected With A Customized Ic -Steps Towards A Fully Integrated Ecg Sensor

A $136\mathrm{G}\Omega$-Input-Impedance Active Electrode for Non-Contact ECG Using Auto-Calibrated Positive Feedback and Capacitance Scaling in Femtofarad Resolution

A 136-GΩ Input-Impedance Active Electrode for Non-Contact Biopotential Signals Monitoring

Non-contact Electrocardiogram Measuring Method Based on Capacitance Coupling Electrodes with Ultra-High Input Impedance.

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

A 382nVrms 100GΩ@50Hz Active Electrode for Dry-Electrode EEG Recording

An Active Dry Electrode Ecg Interface Circuit for Wearable Sensors.

A 15.5b-ENOB 335mVpp-Linear-Input-Range 4.7GΩ-Input-Impedance Direct-ADC Based Analog Front-End

Heart Monitor Using Flexible Capacitive ECG Electrodes

Low Noise, High Input Impedance Digital-Analog Hybrid Offset Suppression Amplifier for Wearable Dry Electrode ECG Monitoring

Ultra-High Input Impedance, Low Noise Integrated Amplifier for Noncontact Biopotential Sensing

A High DR High-Input-Impedance Programmable-Gain ECG Acquisition Interface with Non-inverting Continuous Time Sigma-Delta Modulator

A Noncontact ECG Sensing System With a Micropower, Ultrahigh Impedance Front-End, and BLE Connectivity

Non-Contact Electrocardiograms Acquisition Method Based on Capacitive Coupling

Flexible Non-Contact Electrodes for Minimizing Artifacts in Electrocardiograms Measurement During Motion

MEMS-based flexible capacitive electrode for ECG measurement

[Technical Research of Non-contact Electrocardiogram Based on Capacitive Coupling].