Abstract:This article describes an ultra-high input-impedance active electrode (AE) circuit and the system to sense biopotential signals through a capacitively coupled interface. Various techniques from both circuit and system aspects are used to eliminate the input parasitic capacitance of the AE. On-chip parasitic capacitance is compensated by an auto-calibrated positive feedback loop (PFL) without applying any reference signal. A capacitor down-scaling technique combined with SAR-assisted PFL calibration enables femtofarad-level resolution of the capacitor array, alleviating the practical constraints of the conventional PFL to implement a small capacitor below 10 fF. Besides, a dummy input structure ensures that the pad and electrostatic discharge (ESD) capacitances are also canceled by the PFL, while off-chip parasitic capacitance on the printed circuit board (PCB) is nulled by active shielding. Fabricated in a standard 0.18- $\mu$ m 1P6M CMOS process, the AE achieves an ultra-high input impedance of 136 G $\Omega$ at 60 Hz (average of 10 samples). This is equivalent to an input capacitance of 19.5 fF and corresponds to a 2.7 $\times$ –68 $\times$ improvement over the state-of-the-art. The AE exhibits an input signal range of 700 mV $_{\mathrm{pp}}$ and an input-referred noise of 0.72 $\mu $ V $_{\mathrm{rms}}$ (0.5–100 Hz) while consuming 10.46 $\mu $ W from a 1.2-V supply. Each AE integrates an IC and a 3-cm $^{2}$ copper electrode on the PCB, and the wearable system prototypes successfully measured high-quality electrocardiogram (ECG) and electroencephalogram (EEG) signals from test subjects through capacitively coupled interfaces.

A Noncontact ECG Sensing System With a Micropower, Ultrahigh Impedance Front-End, and BLE Connectivity

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

An Active-Cable Connected ECG Monitoring System for Ubiquitous Healthcare

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

Evaluation Of Non-Contact Flexible Electrodes Connected With A Customized Ic -Steps Towards A Fully Integrated Ecg Sensor

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

A Non-Contact Compact Portable ECG Monitoring System

A Wireless 8-Channel ECG Biopotential Acquisition System for Dry Electrodes

Low-Power Wireless Wearable ECG Monitoring Chestbelt Based on Ferroelectric Microprocessor

A Low-Power Portable ECG Sensor Interface with Dry Electrodes

Ultra-High Input Impedance, Low Noise Integrated Amplifier for Noncontact Biopotential Sensing

A 136-GΩ Input-Impedance Active Electrode for Non-Contact Biopotential Signals Monitoring

An ECG-on-Chip for Wearable Cardiac Monitoring Devices

A Low-Power, Wireless, Real-Time, Wearable Healthcare System

A 0.6V 3.8μw ECG/bio-impedance Monitoring IC for Disposable Health Patch in 40nm CMOS

A System-on-chip and Paper-Based Inkjet Printed Electrodes for a Hybrid Wearable Bio-Sensing System

A Wearable ECG Monitoring Device with Flexible Embedded Denoising and Compression

A flexible ECG patch compatible with NFC RF communication

Wearable System Based on Ultra-Thin Parylene C Tattoo Electrodes for EEG Recording

Flexible Non-contact Electrodes for Wearable Biosensors System on Electrocardiogram Monitoring in Motion