A 136-GΩ Input-Impedance Active Electrode for Non-Contact Biopotential Signals Monitoring

Tianxiang Qu,Peizhuo Wang,Liangbo Lei,Zhiliang Hong,Jiawei Xu

DOI: https://doi.org/10.1109/jssc.2023.3284524

IF: 5.4

2024-01-01

IEEE Journal of Solid-State Circuits

Abstract:This article describes an ultra-high input-impedance active electrode (AE) circuit and the system to sense biopotential signals through a capacitively coupled interface. Various techniques from both circuit and system aspects are used to eliminate the input parasitic capacitance of the AE. On-chip parasitic capacitance is compensated by an auto-calibrated positive feedback loop (PFL) without applying any reference signal. A capacitor down-scaling technique combined with SAR-assisted PFL calibration enables femtofarad-level resolution of the capacitor array, alleviating the practical constraints of the conventional PFL to implement a small capacitor below 10 fF. Besides, a dummy input structure ensures that the pad and electrostatic discharge (ESD) capacitances are also canceled by the PFL, while off-chip parasitic capacitance on the printed circuit board (PCB) is nulled by active shielding. Fabricated in a standard 0.18- $\mu$ m 1P6M CMOS process, the AE achieves an ultra-high input impedance of 136 G $\Omega$ at 60 Hz (average of 10 samples). This is equivalent to an input capacitance of 19.5 fF and corresponds to a 2.7 $\times$ –68 $\times$ improvement over the state-of-the-art. The AE exhibits an input signal range of 700 mV $_{\mathrm{pp}}$ and an input-referred noise of 0.72 $\mu $ V $_{\mathrm{rms}}$ (0.5–100 Hz) while consuming 10.46 $\mu $ W from a 1.2-V supply. Each AE integrates an IC and a 3-cm $^{2}$ copper electrode on the PCB, and the wearable system prototypes successfully measured high-quality electrocardiogram (ECG) and electroencephalogram (EEG) signals from test subjects through capacitively coupled interfaces.