Abstract:An ultra-low power ECG processor ASIC (application specific integrated circuit) with R-wave detection and data compression is presented, which is designed for the long-term implantable cardiac monitoring (ICM) device for arrhythmia diagnosis. An adaptive derivative-based detection algorithm with low computation overhead for potential arrhythmia recording is proposed to detect arrhythmia with the occasional abnormal heart beats. In order to save as much as possible cardiac information with the limited memory size available in the ICM device, a hierarchical data buffer structure is proposed which saves 3 types of data, including the raw ECG data segments of 2 seconds, compressed ECG data segments of 45 seconds, and R-peak values and interval lengths of >2000 beat cycles. A modified swinging-door-trending (SDT) method is proposed for the ECG data compression. The ASIC has been implemented based on fully-customized near-threshold standard cells using the thick-gate transistors in 65-nm CMOS technology for low dynamic power consumption and leakage. The ASIC core occupies a die area of 1.77 mm2. The measured total power is 2.63 μW, which is among the ECG processors with the lowest core power consumption. It exhibits a relatively high positive precision rate (P+) of 99.3% with a sensitivity of 98.2%, in contrast to the similar designs in literature with the same core power consumption level. Also, an ECG data compression ratio (CR) of up to 17.0 has been achieved, with a good trade-off between the compression efficiency and loss.

A High DR High-Input-Impedance Programmable-Gain ECG Acquisition Interface with Non-inverting Continuous Time Sigma-Delta Modulator

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

Low Noise, High Input Impedance Digital-Analog Hybrid Offset Suppression Amplifier for Wearable Dry Electrode ECG Monitoring

A 400 GΩ Input-Impedance Active Electrode for Non-Contact Capacitively Coupled ECG Acquisition with Large Linear-Input-Range and High CM-Interference-Tolerance

A Power Efficient ECG Front-End with Input-Adaptive Gain Reaching 67.6-Db Dynamic Range

A 20 Μw Dual-Channel Analog Front-End in 65nm CMOS for Portable ECG Monitoring System

A 11G-Input-Impedance 700mV<sub>pp</sub>-Input-Signal-Range 87dB-SNDR Direct-Digitization AFE for Wearable EEG Recording

A 11GΩ-Input-Impedance 700mV<inf>pp</inf>-Input-Signal- Range 87dB-SNDR Direct-Digitization AFE for Wearable EEG Recording

A Compact Sub-μW CMOS ECG Amplifier With 57.5-MΩ Zin, 2.02 NEF, 8.16 PEF and 83.24-dB CMRR

A 66-Db Sndr, 8-Mu W Analog Front-End For Ecg/Eeg Recording Application

A 107.6 dB-DR Three-Step Incremental ADC for Motion-Tolerate Biopotential Signals Recording

Ultra-High Input Impedance, Low Noise Integrated Amplifier for Noncontact Biopotential Sensing

A 1.92 Μa Always-on ECG Monitoring Mixed-Signal SoC for Implantable Medical Application.

A 136G-Input-Impedance Active Electrode for Non-Contact ECG Using Auto-Calibrated. Positive Feedback and Capacitance Scaling in Femtofarad Resolution

A Low-Power Portable ECG Sensor Interface with Dry Electrodes

A 2.63 μW ECG Processor With Adaptive Arrhythmia Detection and Data Compression for Implantable Cardiac Monitoring Device

An ECG-on-Chip for Wearable Cardiac Monitoring Devices

A 108db DR Hybrid-CTDT Direct-Digitalization ΔΣ-ΣM Front-End with 720mvpp Input Range and >300mv Offset Removal for Wearable Bio-Signal Recording.

An 800MΩ-Input-Impedance 95.3dB-DR Δ-ΔΣ AFE for Dry-Electrode Wearable EEG Recording