Abstract:Based on the attenuation theory of Gamma ray under the count rate model,a density measurement system for the endothermic hydrocarbon fuels at high pressure and low temperature was designed,with pressure up to 10 MPa and temperature from 233 K to 333 K. The combined relative standard uncertainty of the density measurement was determined to be 0.13%-1.46%. N-hexane and the binary mixture of n-heptane and n-octane with the mass ratio 1:1 were used to calibrate the density measurement system. The results showed that the maximum relative deviation was 0.67%,and the absolute mean values of relative deviation were 0. 22% and 0.07%,respectively. Then one kind of hydrocarbon fuel A was used for density measurement at pressures of 0.7 MPa,3.0 MPa and 6.0 MPa,and temperature from 234. 15 to 323.45 K. The isobaric thermal expansion coefficient was also calculated. Results showed that the isobaric thermal expansion coefficient increases with the test temperature under all three pressures.When temperature is low,the high pressure is not conducive to heat diffusion in the fluid. In addition,it was found that when the temperature is close to 230.65 K,the hydrocarbon fuel A is solidified in the pre-cooling pipeline,leading to a sharp increase in the working pressure of the system. This presented density measurement system is expected to serve as a stepping-stone for the development of the density measurement for the hydrocarbon fuels at low temperature.

On-line Measurement of Isobaric Specific Heat Capacity for Endothermic Hydrocarbon Fuel at High Temperature

MEASUREMENT OF HEAT SINK FOR ENDOTHERMIC FUELS

Design of A Flow Calorimeter for Hydrocarbon Fuel at Temperatures from (330 to 900) K and Pressures Up to 6.0 Mpa

Experimental Study on Density Measurement of Endothermic Hydrocarbon Fuels under High Pressure and Low Temperature

Measurement of Isobaric Specific Heat of Emulsified Kerosene at Supercritical Pressure

Study on thermal capacity of endothermic hydrocarbon fuel by high-temperature calorimeter

Novel Measurement of Isobaric Specific Heat Capacity for Kerosene Rp-3 at High Temperature and High Pressure

Density measurements of endothermic hydrocarbon fuel using random temperature signal cross-correlation

Design of A Gamma Densitometer for Hydrocarbon Fuel at High Temperature and Supercritical Pressure

Isobaric Specific Heat Capacity Measurements of n-Decane at Super-Critical Pressures

A Novel Measurement Method of Isobaric Specific Heat Capacity for n-Decane Under High Temperature and High Pressure

Viscosity Measurement of Endothermic Fuels at Temperatures from 303 K to 673 K and Pressures Up to 5.00 MPa

Measurements of Coefficient of Convective Heat Transfer for Endothermic Hydrocarbon Fuel Up to Supercritical Pressures

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Density Measurements of Endothermic Hydrocarbon Fuel at Sub- and Supercritical Conditions

Isobaric Specific Heat Capacity Measurement for Kerosene Rp-3 in the Near-Critical and Supercritical Regions

Isobaric Specific Heat Capacities of Emulsified Kerosene at High Temperature and Pressure

Viscosity Measurements of Hydrocarbon Fuel at Temperatures from (303.2 to 513.2) K and Pressures Up to 5.1 MPa Using a Two-Capillary Viscometer

Viscosity Measurements of Endothermic Hydrocarbon Fuel from (298 to 788) K under Supercritical Pressure Conditions

Isobaric Heat Capacity Measurements of Methanol by Flow Calorimeter at Elevated Temperatures and Pressures

Convective Heat Transfer and Pressure Drop Characteristics of Near-Critical-pressure Hydrocarbon Fuel in a Minichannel