Abstract:Hydrocarbons are widely used in various industrial processes. Heat capacity of liquids is one of the basic properties in engineering equipment design and establishment of equations of state. Therefore, it is important to develop reliable and accurate models for representing heat capacities of hydrocarbon liquids. In this paper, a new model was proposed to calculate the isobaric heat capacity (cp) of saturated hydrocarbons (contain only single bonds between carbon atoms, including n-alkanes, branched alkanes and cycloalkanes) in liquid phase over a wide range of temperature and pressure. The present model was inspired by the Peng-Robinson equation of state and general thermodynamic relationships, with an empirical correction to improve the heat capacity formulation by Peng-Robinson equation for representing isobaric heat capacity of saturated hydrocarbons in liquid phase. The proposed model was used to reproduce the isobaric heat capacity of 19 compounds. The average absolute deviations between the results of the present model and corresponding experimental data are 0.47% with known critical point, acentric factor, ideal gas isochoric/isobaric heat capacity and at least two different experimental cp data points. Moreover, the isobaric heat capacity data obtained by the proposed model were compared with the calculations from other models (Peng Robinson equation and Helmholtz equation). The proposed model offers a simple and reliable way to obtain the isobaric heat capacity of saturated hydrocarbons in liquid state with satisfactory accuracy. In addition, the new model also revealed an excellent extrapolation ability in the high temperature region, which means researchers can obtain high-temperature liquid cp data even not reported by using present model based on several available experimental cp data points.

Calorimetric Determination of the Vapor Heat Capacity of Petroleum Cuts

Study on isobaric specific heat capacity and enthalpy of petroleum cuts

Experimental-Determination of the Isobaric Specific-Heat Capacities of Multicomponent Vapors Up to Temperatures of 600-K

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Vapor Heat Capacity of Binary and Ternary Systems

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

A Set of Vapor-Flow Calorimeter and the Heat Capacities of Benzene and Benzene-Cyclohexane

Determination of vapor heat capacities of acetone-chloroform, benzene-carbon tetrachloride and benzene-ethanol binary systems

A New Flow Calorimeter For The Determination Of The Isobaric Heat-Capacity Of Vapors

The Vapor Heat Capacities of Acetone-Chloroform, Benzene-Carbon Tetrachloride and Benzene-Ethanol Binary Mixtures

Measurements of Vapor Pressure and Vapor-Liquid Equilibria of Hydrocarbon Fuels

Vapor Heat Capacities of Acetic Acid + 4-Methyl-2-pentanone, at Atmospheric Pressure

Vapor Heat Capacities of Some Polar–polar Binary Systems

Calculation of vapor pressure of petroleum fractions by continuous thermodynamics method

Design of A Flow Calorimeter for Hydrocarbon Fuel at Temperatures from (330 to 900) K and Pressures Up to 6.0 Mpa

Isobaric Specific Heat Capacities of Emulsified Kerosene at High Temperature and Pressure

On-line Measurement of Isobaric Specific Heat Capacity for Endothermic Hydrocarbon Fuel at High Temperature

Isobaric Heat Capacity Measurements of Methanol by Flow Calorimeter at Elevated Temperatures and Pressures

Modeling heat capacity of saturated hydrocarbon in liquid phase over a wide range of temperature and pressure

Isobaric Molar Heat Capacities Measurement of Binary Mixtures Containing Ethyl Laurate and Ethanol at High Pressures

Measurement of Isobaric Specific Heat of Emulsified Kerosene at Supercritical Pressure