Abstract:By using a specially contrived experimental technique, the partition equilibrium of 4-carboxybenzaldehyde (4-CBA) between crude terephthalic acid crystals and the corresponding aqueous acetic acid solution was achieved. The equilibrium mole fractions of 4-CBA in both the liquid and solid phases were measured over a temperature range from (423.2 to 453.0) K, and the mass fractions of acetic acid in the solvent mixtures ranged from 0.800 to 0.995. The partition coefficients, defined as the ratio of the equilibrium mole fraction of 4-CBA in the solid phase to the equilibrium mole fraction of 4-CBA in the liquid phase, were experimentally determined. The experimental results show that: (1) within the temperature range of the measurements, the partition coefficient shows a decreasing trend as the temperature increases at a constant solvent composition, and (2) within the solvent composition range of the measurements, the partition coefficient increases with increasing water content in the solvents at a constant temperature. The experimental data are correlated by the nonrandom two liquids (NRTL) activity coefficient model, and the model parameters are determined in a nonlinear optimization. The fit of the correlated results is fairly good. The comparison of the predicted and experimental partition coefficients at temperatures of (423.2 to 453.0) K and the mass fraction of acetic acid in the solvent mixture at 0.950 shows that the NRTL activity coefficient model could be used as a suitable toot in predicting the partition coefficient of 4-CBA between crude terephthalic acid crystals and the corresponding aqueous acetic acid solution.

Vapor Heat Capacities of Acetic Acid + 4-Methyl-2-pentanone, at Atmospheric Pressure

Heat Capacities of Binary Mixtures of Acetic Acid with Acetic Anhydride and Methenamine at Different Temperatures

Densities and Viscosities of Binary Mixtures of Acetic Acid with Acetic Anhydride and Methenamine at Different Temperatures

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

The Vapor Heal Capacities Of Acetone-Chloroform, Benzene-Carbon Tetrachloride And Benzene-Ethanol Binary Mixtures

Solubilities of Benzoic Acid and Phthalic Acid in Acetic Acid Plus Water Solvent Mixtures

Liquid−Liquid Equilibria for the Ternary System Water + Acetic Acid + Propyl Acetate

Vapor–liquid equilibria for water + acetic acid + (N,N-dimethylformamide or dimethyl sulfoxide) at 13.33 kPa

Molar excess enthalpies of ethyl acetate+alkanols at T=298.15K, p=10.0MPa

Measurement and Study on the Vapor Heat Capacities of Carboxylic Acids

Determination of vapor heat capacities of acetone-chloroform, benzene-carbon tetrachloride and benzene-ethanol binary systems

A Set of Vapor-Flow Calorimeter and the Heat Capacities of Benzene and Benzene-Cyclohexane

Isobaric Vapor-Liquid Equilibrium for Acetic Acid+dimethyl Sulfoxide

The Molar Heat Capacities of (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (Acetone+trichloromethane)

Isobaric vapor-liquid equilibrium of acetic acid-N, N-dimethylformamide system

Partition Coefficient of 4-Carboxybenzaldehyde Between Crude Terephthalic Acid Crystals and the Corresponding Aqueous Acetic Acid Solution at (423.2 to 453.0) K

Experimental-Determination of the Isobaric Specific-Heat Capacities of Multicomponent Vapors Up to Temperatures of 600-K

Solubility of 1,2,4-Benzenetricarboxylic Acid in Acetic Acid + Water Solvent Mixtures

Measurement of Vapor Liquid Equilibrium for System of Ethyl Acetate-Pyridine at Different Pressures