Abstract:Using a high-temperature flow calorimeter, we determined the molar heat capacities at constant pressureCp, mof four binary mixtures at three different temperatures (410.3, 514.7, and 630.6) K and various compositions. The binaries investigated are: (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (acetone+trichloromethane). AtT630.6 K, all these mixtures showed ideal gas behavior,i.e.heat capacity additivity. However, excess heat capacities were found at lower temperatures, particularly in (Lewis base+acidic proton) and (non-polar+polar) binary systems, such as (acetone+trichloromethane), (benzene+acetone), and (benzene+trichloromethane), but no significant excess heat capacities were detected in (non-polar+non-polar) systems. The excess heat capacity can be attributed to intermolecular interaction between unlike molecules. The heat capacities of the binary mixtures considered in the experiment were also calculated using both cubic (van der Waals)-type and virial-type equations of state: PR EOS and truncated virial EOS, respectively. The two EOSs gave comparable results. However, there are some statistically significant biases between the calculated results and experimental values in systems containing a polar component. This may be due to the limitations of the mixing rules used in the calculation.

Determination of vapor heat capacities of acetone-chloroform, benzene-carbon tetrachloride and benzene-ethanol binary systems

The Vapor Heat Capacities of Acetone-Chloroform, Benzene-Carbon Tetrachloride and Benzene-Ethanol Binary Mixtures

Heat Capacities of Binary Mixtures of Acetic Acid with Acetic Anhydride and Methenamine at Different Temperatures

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Vapor Heat Capacity of Binary and Ternary Systems

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Vapor Heat Capacities of Some Polar–polar Binary Systems

The Molar Heat Capacities of (benzene+tetrachloromethane), (benzene+trichloromethane), (benzene+acetone), and (Acetone+trichloromethane)

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Experimental-Determination of the Isobaric Specific-Heat Capacities of Multicomponent Vapors Up to Temperatures of 600-K

Vapor–Liquid Equilibria for the Binary Systems Difluoromethane (R32) + Trans-1,1,1,4,4,4-hexafluoro-2-butene (r1336mzz(e)) and Fluoroethane (R161) + Trans-1,1,1,4,4,4-hexafluoro-2-butene (R1336mzz(e))

Vapor Heat Capacities of Acetic Acid + 4-Methyl-2-pentanone, at Atmospheric Pressure

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

A Set of Vapor-Flow Calorimeter and the Heat Capacities of Benzene and Benzene-Cyclohexane

MEASUREMENTS AND THERMODYNAMIC MODELING OF VAPOR-LIQUID EQUILIBRIA FOR BINARY SYSTEMS OF ISOPROPYL CHLOROACETATE WITH CYCLOHEXANE, ISOPROPANOL AND BENZENE AT 101.3 kPa

Molar excess enthalpies of ethyl acetate+alkanols at T=298.15K, p=10.0MPa

Calorimetric Determination of the Vapor Heat Capacity of Petroleum Cuts

Measurement and Study on the Vapor Heat Capacities of Carboxylic Acids

Study and Applications of Binary and Ternary Azeotropes

Vapor−Liquid Equilibria for the Quaternary System Ethanol + Acetone + Benzene + Hexane

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa