Abstract:This paper presents an experimental and numerical investigation on the cooling performances of a flat endwall, which is made of super-alloy. The endwall passage is configured by two semi-profiled vanes. In the flat endwall, there are 34 cylindrical film holes located at the leading edge region, near the pressure side and upstream inlet, respectively. The experiments were carried out in the hot wind tunnel at the University of Science and Technology of China. Cooling characteristics were captured at different blowing ratios and mainstream temperatures by an infrared thermal image system. The experiments exhibited an interesting phenomenon, i.e. one can get a similar temperature contour at different mainstream and coolant temperatures but the same other conditions if using the maximal and minimal temperatures as the limit values in the contour scale. The experimental data were used to validate the numerical strategy. To demonstrate this similar phenomenon at the real condition of gas turbine operations, numerical simulations were conducted. The numerical results indicated that at the same blowing ratio and mainstream Reynolds number, when mainstream temperature varies from 1700K to 1950K but cooling air temperature keeps at 850K, or the cooling air temperature changes from 750K to 950K but the mainstream temperature keeps at 1700K, the temperature contours generated by the scale of nature maximal and minimal temperatures are very similar. Using linear relationships to fit these maximal and minimal temperatures in the contour scales, the maximal fitting error is less than 0.1%. Using the similar phenomenon and linear relationships, one can easily predict any cooling effect at the condition between two experimental states or two simulation conditions. Therefore this similarity is very useful for the experimental investigations into endwall cooling performances and the design of film cooling configurations.

BUILDING OF ENDOTHERMIC FUEL COOLING SIMULATION SYSTEM

MEASUREMENT OF HEAT SINK FOR ENDOTHERMIC FUELS

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Device and Calculation Research for Rolling Combustion Chamber Cooling Structure

Bar and Plate EGR Cooler Simulation and Experimental Verification

Conceptual Design and Dynamic Simulation of Thermal Management for Fighter Aircraft Fuel System

A conjugate numerical model for the thermal analysis of the regenerative cooling of an X-51A-like aircraft

Design and Analysis of Cooling Water System for ECRH and ICRF Testing Bench

Research on Cooling-Temperature Control Strategy of Fuel-Cell Engine Test Bench

Heat Transfer Simulation of Fuel Transport Cask for High Temperature Gas Cooled Reactor

Experiment and Simulation on a Thermal Management Scheme of Intermediate Circulation Based on Heat Current Method

Working state map of hydrocarbon fuels for regenerative cooling

Three-dimensional Coking Simulation of Endothermic Hydrocarbon Fuels in Rectangular Cooling Channels

Design and Simulation of Thermal Management System with Liquid As the Cooling Media

An Experimental and Numerical Investigation on Endwall Film Cooling

Matlab/Simulink and AMESim Co-Simulation for PEMFC Cooling System

Analysis of Aircraft Integrated Thermal Management Using Fuel As Heat Sink

Numerical Investigation of Conjugated Heat Transfer of the Plate-Type Fuel Assembly in the Research Reactor

Experimental Investigation on Flow Boiling Heat Transfer Characteristics of Endothermic Hydrocarbon Fuel and Its Visualization at High-Temperature Conditions

Simulation and Optimization Analysis of Vehicle Cooling System

Modelling and Simulation Methodology of Channel Cooling Using Hydrocarbon Fuel As Coolant under Supercritical Pressures