Abstract:The objective of this study is to develop a particle collector by using a micro gas cyclone with a body diameter of 10 mm. Design and performance of a cyclone separator is determined by collection efficiency and pressure drop. The behavior of a rectangular inlet-type cyclone for relatively high solid loading rates is reported in this study. For different solid loading flow rates varying from 11.7 to 16.7 liter per min, pressure drop and collection coefficient were evaluated through simulation and experimental work. The experimental part of this study was conducted using Snifter MA+ device. Since the Snifter MA+ is designed to handle flows which are approximated by laminar conditions and the flow regime within the cyclone is mostly turbulent, in order to achieve a suitable performance, the flow in the cyclone should be controlled to be close to laminar conditions. Given these circumstances, the highest cyclone efficiency was recorded for the lowest flow rate and in turbulent condition. The obtained efficiency shows that the cyclone has a reliable performance. As flow rate decreases, pressure drop reduces as well. In order to investigate the pressure drop behavior, velocity and flow trajectories for different flow rates, SOLIDWORKS software, which is applied for drawing and also for simulation was utilized to simulate the model. The simulation results show that by increasing the flow rate, pressure drop also increases.

EXperimetal Study on the Diffusion Square Cyclone Seoarator

Experimental study on a new type of cyclone separator for fine particles

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

Experimental Study on the Particle Distribution in a Square Cyclone Separator

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Experimental Research on Square Cyclone

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

Experimental Research on the Performance of a Cyclone Impeller Type Separator

Experimental Study of the Separation Performance of a Square Separator Assuming a Horizontal Heat Exchange Mode

Numerical Study of the Flow Field and Particle Separation Characteristics for a Diffusion Type Cyclone Separator

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

Experimental study on the separation performance of a novel oil–gas cyclone separator

Study of the performance and flow field of a new spiral-roof cyclone separator

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Experimental investigation on separation characteristics of axial cyclone separator

Experimental Study on the Three-Dimensional Two-Phase Flow Field in a Hydrocyclone

The Effect of Inlet Velocity, Gas Temperature and Particle Size on the Performance of Double Cyclone Separator