Abstract:Optoelectronic integration technology which utilizes CMOS process to achieve the integration of photonic devices has the advantages of high integration, high speed and low power consumption. The Ge1-xSnx alloys have been widely used in photodetectors, light-emitting diodes, lasers and other optoelectronic integration areas because they can be converted into direct bandgap semiconductors as the Sn component increases. However, the solid solubility of Sn in Ge as well as the large lattice mismatch between Ge and Sn resulting from the Sn composition cannot be increased arbitrarily: it is limited, thereby bringing a lot of challenges to the preparation and application of direct bandgap Ge1-xSnx. Strain engineering can also modulate the band structure to convert Ge from an indirect bandgap into a direct bandgap, where the required stress is minimal under biaxial tensile strain on the (001) plane. Moreover, the carrier mobility, especially the hole mobility, is significantly enhanced. Therefore, considering the combined effect of alloying and biaxial strain on Ge, it is possible not only to reduce the required Sn composition or stress for direct bandgap transition, but also to further enhance the optical and electrical properties of Ge1-xSnx alloys. The energy band structure is the theoretical basis for studying the optical and electrical properties of strained Ge1-xSnx alloys. In this paper, according to the theory of deformation potential, the relationship between Sn component and stress at the critical point of bandgap transition is given by analyzing the bandgap transition condition of biaxial tensile strained Ge1-xSnx on the (001) plane. The energy band structure of strained Ge1-xSnx with direct bandgap at the critical state is obtained through diagonalizing an 8-level k . p Hamiltonian matrix which includes the spin-orbit coupling interaction and strain effect. According to the energy band structure and scattering model, the effective mass and mobility of carriers are quantitatively calculated. The calculation results indicate that the combination of lower Sn component and stress can also obtain the direct bandgap Ge1-xSnx, and its bandgap width decreases with the increase of stress. The strained Ge1-xSnx with direct bandgap has a very high electron mobility due to the small electron effective mass, and the hole mobility is significantly improved under the effect of stress. Considering both the process realization and the material properties, a combination of 4% Sn component and 1.2 GPa stress or 3% Sn component and 1.5 GPa stress can be selected for designing the high speed devices and optoelectronic devices.

Theoretical Analysis of Performance Enhancement in GeSn/SiGeSn Light-Emitting Diode Enabled by Si3N4 Liner Stressor Technique.

Simulation and optimization of strained GeSn laser with SiN-induced stress

Improving Performance of Si/CdS Micro-/Nanoribbon P-N Heterojunction Light Emitting Diodes by Trenched Structure

GeSn/SiGeSn Photonic Devices for Mid-Infrared Applications: Experiments and Calculations

Design of Tensile-Strained GeSn/SiGeSn Structure for Low Threshold Mid-infrared Laser Application

Theoretical Investigation of Tensile-Strained GeSn / SiGeSn Multiple Quantum Well Laser Wrapped in Si 3 N 4 Liner Stressor Volume 10 , Number 1 , February 2018

Theoretical Investigation of Tensile-Strained GeSn/SiGeSn Multiple Quantum Well Laser Wrapped in Si 3N4 Liner Stressor

Strained Germanium LED with SiN Stressor and Microbridge based on Edge Stress Concentration

Theoretical Investigation of Strain-Adjustable Ge0.92Sn0.08 Light-Emitting Diodes with Giant Magnetostrictive Stressor for Short-Wave Infrared Light Source

Stress Management on Underlying GaN-based Epitaxial Films: A New Vision for Achieving High-Performance LEDs on Si Substrates

Strained GeSn laser with multiple fins structure based on SiN stress

Direct-Bandgap Electroluminescence from Germanium with Subband Engineering Utilizing a Metal-Oxide-Semiconductor Structure

Strain Engineering for Germanium-on-Insulator Mobility Enhancement with Phase Change Liner Stressors*

Strain-Induced Enhancement of Electroluminescence from Highly Strained Germanium Light-Emitting Diodes

Tensile-Strained Mid-Infrared GeSn Detectors Wrapped in Si 3N 4 Liner Stressor: Theoretical Investigation of Impact of Device Architectures

Simulation investigation of tensile strained GeSn fin photodetector with Si(3)N(4) liner stressor for extension of absorption wavelength.

Calculations of Energy Band Structure and Mobility in Critical Bandgap Strained Ge1?xSnxbased on Sn Component and Biaxial Tensile Stress Modulation

Tensile strained Ge0.90Sn0.10 photodiode integrated with Si3N4 liner stressor for mid-infrared applications

Growth and Strain Modulation of GeSn Alloys for Photonic and Electronic Applications

Strained Sigesn Formed by Sn Implant into Sige and Pulsed Laser Annealing

Theoretical investigation of tensile strained GeSn waveguide with Si₃N₄ liner stressor for mid-infrared detector and modulator applications.