Abstract:The strong piezoelectric field present in InGaN/GaN heterostructure quantum wells severely reduces the light emission efficiency of multiple quantum well (MQW) structures. To address this issue, a strain modulation interlayer is commonly used to mitigate the piezoelectric polarization field and improve the luminescence performance of the devices. To investigate the impact and mechanism of strain modulation in the InGaN/GaN superlattice (SL), epitaxial wafers were fabricated with an n-type InGaN/GaN SL interlayer sample, along with a corresponding control sample. By measuring the temperature-dependent photoluminescence (PL) spectra of the epitaxial wafers, experimental results show that the introduction of an SL interlayer leads to a shorter emission wavelength and an enhanced internal quantum efficiency. As the temperature increases, a blue shift of the PL peak is observed. However, for the sample with an SL interlayer, the blue shift of the PL peak with temperature is relatively small. Electroluminescence (EL) experiments indicate that the introduction of an SL interlayer significantly increases the integrated intensity of the EL peak and reduces its full width at half maximum. These phenomena collectively suggest that the incorporation of a superlattice interlayer can partially suppress the quantum-confined Stark effect (QCSE) that affects the light emission efficiency. Theoretical calculations demonstrated that the introduction of a superlattice strain layer before the growth of the multiple quantum well active region can weaken the polarization-induced built-in electric field, reduce the tilt of the energy bands in the multiple quantum well active region, increase the overlap of electron and hole wave functions, enhance the emission probability, shorten the radiative recombination lifetime, and promote competition between radiative and non-radiative recombination, thereby achieving higher recombination efficiency and improved light emission intensity. This study provides experimental and theoretical evidence that the strain modulation SL interlayer can effectively improve the device performance and offer guidance for optimizing the structural design of devices.

Theoretical Investigation of Tensile-Strained GeSn/SiGeSn Multiple Quantum Well Laser Wrapped in Si 3N4 Liner Stressor

Design of Tensile-Strained GeSn/SiGeSn Structure for Low Threshold Mid-infrared Laser Application

Simulation and optimization of strained GeSn laser with SiN-induced stress

Strained GeSn laser with multiple fins structure based on SiN stress

Analysis and optimization of 1.55 μm InGaAs/InGaAsP strained multiple quantum well lasers

A Self-Consistent Numerical Approach for Characterizing the Band Structures and Gain Spectrum of Tensile-Strained and N(+)-Doped Ge/GeSi Quantum Wells

All‐Around HfO2 Stressor for Tensile Strain in GeSn‐on‐Insulator Nanobeam Lasers

Investigation of SiGeSn/GeSn/SiGeSn Quantum Well Structures and Optically Pumped Lasers on Si

Different Strain Relief Behaviors in Al0.35ga0.65n/Gan Multiple Quantum Wells on Gan/Sapphire Templates with Aln/Gan Supperlattices and Low-Temperature Aln Interlayers

Ultra-low threshold cw and pulsed lasing in tensile strained GeSn alloys

1D photonic crystal direct bandgap GeSn-on-insulator laser

Study of Band Structure in PbSe/PbSrSe Quantum Wells for Midinfrared Laser Applications

Investigation of lasing in highly strained germanium at the crossover to direct band gap

Characteristic Analysis Of Ingaas/Ingaasp Strained Quantum Well Lasers

Study of short-wavelength red semiconductor laser using high Ga composition GaInP quantum well based on Ge/SiGe substrate

Study on the strain modulation effect of superlattice interlayer on InGaN/GaN multiple quantum well

Influence of Indium Composition in the Prestrained Ingan Interlayer on the Strain Relaxation of Ingan/Gan Multiple Quantum Wells in Laser Diode Structures

Study of SiGeSn/GeSn single quantum well towards high-performance all-group-IV optoelectronics

Threshold Characteristics of 1.55-Μm InGaAs/InGaAsP Strain-Compensated Quantum Well Lasers with Zero Net Strain

Mid-infrared group-IV nanowire laser

Reliability enhancement of InGaAs/AlGaAs quantum-well lasers on on-axis Si (001) substrate