Abstract:In this study, a novel sol-gel method is used to synthesize amorphous silica-alumina materials with a narrow mesoporous distribution and various Si/Al molar ratios without using any templates and pore-regulating agents. During the preparation procedure, only inexpensive inorganic salts were used as raw materials, instead of expensive and harmful alkoxides. The precursor sol was dried at room temperature in a vacuum box kept at 60 mmHg until it began to form the gel. The results of a nitrogen sorption experiment indicate that the synthesized materials with different Si/Al molar ratios have similar mesoporous distributions (within 2-12 nm). Moreover, it was found that the material's pore size distribution remains at a similar value during the heat treatment from room temperature to 550 degreesC. On the basis of the nitrogen sorption, TEM, and AFM characterization results, a formation mechanism of mesopores which accounts for the experimental data is also suggested. This suggested mechanism involves rearrangement of the primary particles during the drying process to form the precursors of the similarly sized mesopores. The synthesized materials were characterized by XRD, thermal analysis (TG/DTA), Al-27 and Si-29 MAS NMR spectroscopy, SEM, TEM, and AFM. The results of Al-27 and 29Si MAS NMR indicate that the distribution of silicon and aluminum in the synthesized materials is more uniform and homogeneous than that in the mixed oxides prepared via the traditional sol-gel method even at high alumina contents. The type and density of the acid sites were studied using pyridine adsorption-desorption FTIR spectroscopy. It was shown that the acidity of the synthesized materials is higher than that of the silica-alumina materials prepared by conventional methods.

Synthesis of Sub-Micro-sized Solid Alpha Alumina Fibers with Smooth Surfaces by Sol–gel Method

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Synthesis and characterization of sol–gel alumina nanofibers

A Novel Sol–gel Synthetic Route to Alumina Nanofibers Via Aluminum Nitrate and Hexamethylenetetramine

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

Ultrasonic Synthesis of Silica−Alumina Nanomaterials with Controlled Mesopore Distribution Without Using Surfactants

Preparation of Continuous Alumina Fiber with Nano Grains by the Addition of Iron Sol

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents

Microstructures of Nanosized Alumina Powders Synthesized by Sol-Gel Method

Preparation and Characterization of Alumina Nanofibers by Gas-Solid Reaction Method

The Microstructure, Morphology, and Mechanical Properties of Sol-Gel-derived Amorphous Aluminum Oxide Films

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Preparation of Ultra-High-strength Alumina Microspheres Based on Fiber Reconstruction Via Multistage Low-Carbon Alcohol Elution

Synthesis of γ-alumina via precipitation in ethanol

Synthesis of Gamma-Alumina Nanopowders Using Waste Metal Aluminum and Stability Surfactants

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Synthesis of monolithic aerogel-like alumina via the accumulation of mesoporous hollow microspheres

Size-controlled synthesis of nano α-alumina particles through the sol–gel method

Ultrasound As a Tool to Synthesize Nano-Sized Silica–Alumina Catalysts with Controlled Mesoporous Distribution by a Novel Sol–Gel Process

Coprecipitation Synthesis of Large-Pore-Volume Γ-Alumina Nanofibers by Two Serial Membrane Dispersion Microreactors with a Circulating Continuous Phase

Preparation of Large-Pore-Volume Gamma-Alumina Nanofibers with A Narrow Pore Size Distribution in A Membrane Dispersion Microreactor