Abstract:In this paper, fully dense Si3N4/SiC nano-composites were fabricated through polymer-derived ceramics (PDCs) method and spark plasma sintering technique. Polymer-derived SiAlCN ceramic was synthesized by using polysilazane as preceramic precursor, aluminum tri-sec-butoxide as Al source. Then Si3N4/SiC composites with nanometer sized Si3N4 and SiC phases were formed spontaneously during spark plasma sintering through in-situ phase separation of amorphous SiAlCN ceramics. It's found that with the increasement of Al contents, the densification rate was accelerated significantly and serious degradation of Si3N4 phase was avoided by restricting carbothermal reaction. At the same time, Al contained composites show excellent oxidation/corrosion resistance at 1350 °C and 50% H2O - 50% O2 water vapor environment than that of Al free samples. The Si3N4/SiC composites derived from Al contained PDCs overcomes the trade-off between abnormal grain growth and serious degradation of Si3N4 phase, which is a very tough problem for traditional PDC route (without Al) to fabricate Si3N4/SiC composites. For traditional PDC route, (I) if with traditional sintering additives, abnormal grain growth occurs, nano grains cannot be achieved; (II) if without traditional sintering additives, serious degradation of Si3N4 occurs, Si3N4 and SiC composite cannot be formed. Therefore, Al contained polymer-derived ceramics route opens a promising avenue to fabricate Si3N4/SiC nano-composites with fine grain size, uniform microstructure and excellent oxidation/corrosion resistance.

In-situ synthesized nanocrystalline UO2/SiC composite with superior thermal conductivity

Thermal conductivity of UO2 pellets enhanced by a semi-continuous structure of Ti3SiC2

Fabrication of UO2-BeO composite pellets with superior thermal conductivity based on multi-parameter theoretical analyses

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Interfacial microstructure and thermal resistance of UO2/Mo composites fabricated by spark plasma sintering

Graphite flakes/UO2 fuel pellets with excellent thermal conductivity in radial direction

Synthesis of composite of graphene and UO3 composite via one-step solution chemical reaction and its application to UO2-based accident tolerant fuel

In situ formation of Si3N4–SiC nanocomposites through polymer-derived SiAlCN ceramics and spark plasma sintering

Sintering behavior and thermal conductivity of graphite flakes/uranium dioxide composites

In-situ synthesis and microstructural evolution of a SiC reinforced Al-50Si composite exhibiting exceptional thermal properties

Enhanced performance of thermoelectric nanocomposites based on Cu12Sb4S13 tetrahedrite

Fabrication of Si3N4 ceramics with improved thermal conductivity by carbothermal reduction and two‐step sintering

β-SiC nano-particles enhanced thermal conductivity of pressureless solid-phase sintering SiC

Single-source-precursor synthesis of dense monolithic SiC/(Ti0.25Zr0.25Hf0.25Ta0.25)C ceramic nanocomposite with excellent high-temperature oxidation resistance

Using in-situ conversed nano SiC to bond UHTC particles and construct anti-ablation coating

Fabrication, microstructure, and properties of SiC/Al4SiC4 multiphase ceramics via an in-situ formed liquid phase sintering

UO2–Mo–Be composites for Accident Tolerant Fuel: SPS fabrication, microcracks-free in as-fabricated state and superior thermal conductivity

Enhancing densification rate and the unusual 4H-SiC polytype stabilization in ultrafast high-temperature sintering of α-SiC

Precipitation behavior and mechanical properties of Al-Zn-Mg-Cu matrix nanocomposites: Effects of SiC nanoparticles addition and heat treatment

Simultaneously enhance thermal conductive property and mechanical properties of silicon rubber composites by introducing ultrafine Al2O3 nanospheres prepared via thermal plasma

Preparation of Low-Temperature Sintered UO2 Nanomaterials by Radiolytic Reduction of Ammonium Uranyl Tricarbonate