Abstract:The thermal reliability of two different high-power insulated gate bipolar transistor (IGBT) modules was studied under both conduction and switching regimes by experimental and numerical approaches. Indeed, the reliability of semiconductor devices is tightly linked to the junction temperatures reached in the IGBT, which is a function of the diode chips present in such devices and its operating condition. However, measurements of the semiconductor temperatures are often difficult to be done, thus requiring modeling and simulation tools to accurately evaluate the instantaneous temperature under different thermal loads. For this reason, a transient 3D heat transfer numerical model of two different IGBT power devices was proposed using the Finite Element Method, assuming that heat is dissipated on the IGBT by natural convection and radiation. These simulations were validated with experimental measurements, obtained through infrared thermography, performed for the IGBT modules either opened or enclosed, varying the heat source, the module orientation and under conduction or switching regime. For the switching regime, power losses due to the gate-closing and gate-opening transitions between conducting and non-conducting states were taken into consideration. The heat losses were modeled assuming the time-dependent heat dissipation obtained by previous electrical simulations, and it was compared with time-averaged heat source solutions. Results showed that averaging the heat source can significantly reduce the computational time, allowing quick design explorations. Overall, the numerical model led to deviations of less than 16% over the transient heating and at steady-state. Finally, the impact of a heat sink attached to the IGBT was studied, demonstrating that the proposed model can be used for accurate and quick investigations of potential failures and for the development of more efficient IGBT devices.

Investigation and Classification of Short-Circuit Failure Modes Based on Three-Dimensional Safe Operating Area for High-Power IGBT Modules

A Self-Adaptive Blanking Circuit for IGBT Short-Circuit Protection Based on VCE Measurement

Fault Analysis on Conventional Parallel Inverter Systems

1200-V Trench-FS IGBT: Process-Based Modeling and Short-Circuit Safe Operating Area (SCSOA) Optimization with the TOPSIS Method

A High Speed Short-Circuit Protection Circuit with Current Limitation and Soft Turn-Off for High Power IGBTs

In Situ Diagnosis for IGBT Chip Failure in Multichip IGBT Modules Based on a Newly Defined Characteristic Parameter Low-Sensitive to Operation Conditions

Study of Accelerated Power Cycling Test of IGBT Power Modules

Research on High Power IGBT Short Circuit Protection in Wind Power System

LF-OCT Based Non Destructive Testing for IGBT Module

Testing and Assessment on the Short-Circuit Withstand Capability of Press-Pack IGBT Considering the Unbalanced Clamping Forces

Study and Handling Methods of Power IGBT Module Failures in Power Electronic Converter Systems

Investigation on Short-Circuit Characterization and Optimization of 3.3-kV SiC MOSFETs

A discussion on IGBT short-circuit behavior and fault protection schemes

Fault prediagnosis of power electronic devices in urban new energy system

Comparison of Short-Circuit Safe Operating Areas Between the Conventional Field-Stop IGBT and the Superjunction Field-Stop IGBT

A Transient 3-D Thermal Modeling Method for IGBT Modules Considering Uneven Power Losses and Cooling Conditions

Thermal Management on IGBT Power Electronic Devices and Modules

Comparative Evaluation of Short Circuit Robustness Across Generation of 1.2kv SiC MOSFETs

Thermal and electrical evaluation of insulated gate bipolar transistor (IGBT) power modules