Abstract:In order to obtain high-quality through-silicon via (TSV) arrays for high voltage applications, we optimized the fabrication processes of the Si holes, evaluated the dielectric layers, carried out hole filling by Cu plating, and detected the final structure and electric properties of the TSVs. The Si through-hole array was fabricated in an 8-inch Si substrate as follows: First, a blind Si hole array was formed by the Si deep reactive etching (DRIE) technique using the Bosch process, but with the largest width of the top scallops reduced to 540 nm and the largest notch elimidiameternated by backside grinding, which also opens the bottom ends of the Si blind holes and forms 500-μm-deep Si through holes. Then, the sidewalls of the Si holes were further smoothed by a combination of thermal oxidation and wet etching of the thermal oxide. The insulating capability of the dielectric layers was evaluated prior to metal filling by using a test kit. The metal filling of the through holes was carried out by bottom-up Cu electroplating and followed by annealing at 300 °C for 1 h to release the electroplating stress and to prevent possible large metal thermal expansion in subsequent high-temperature processes. The TSV arrays with different hole diameters and spacing were detected: no visible defects or structure peeling was found by scanning electron microscopy (SEM) observations, and no detectable interdiffusion between Cu and the dielectric layers was detected by energy dispersive X-ray (EDX) analyses. Electric tests indicated that the leakage currents between two adjacent TSVs were as low as 6.80 × 10−10 A when a DC voltage was ramped up from 0 to 350 V, and 2.86 × 10−9 A after a DC voltage was kept at 100 V for 200 s.

Fabrication and Filling Quality Optimization of the High Density and Small Size Through Silicon Via Array for Three-Dimensional Packaging

Influence of Electroplating Current Density on Through Silicon Via Filling

Modeling the Bottom-Up Filling of Through Silicon Vias with Different Additives

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Copper Filling Process for Small Diameter, High Aspect Ratio Through Silicon Via (Tsv)

Microfabrication of Through Silicon Vias (TSV) for 3D SiP

Completely Filling of Through-Silicon-Vias with High Aspect Ratio by High Cavity Physical Vapor Deposition and Electroplating

Research of Vertical via Based on Silicon, Ceramic and Glass

Fabrication and Characterization of Fine Pitch TSV Integration with Self-Aligned Backside Insulation Layer Opening.

A State‐of‐the‐Art Review of Through‐Silicon Vias : Filling Materials, Filling Processes, Performance, and Integration

Advanced 3D Through-Si-Via and Solder Bumping Technology: A Review

A wet process to etch arrayed vias for through silicon via application of 3D packaging

Parametric Study of DRIE Process for Enhancing the Profile-Preserving Property of Square Through Silicon Via

Stress Analysis and Layout Optimization of Nano-TSV in an Advanced Packaging

Optimization of TSV Leakage in Via-Middle TSV Process for Wafer-Level Packaging

Design and analysis of an I-shaped TSV structure for 3D SiP

Bottom-Up Cu Filling of High-Aspect-Ratio through-Diamond vias for 3D Integration in Thermal Management

Fabrication and electrical characterization of sub-micron diameter through-silicon via for heterogeneous three-dimensional integrated circuits

Process Optimization and Performance Evaluation of TSV Arrays for High Voltage Application

Optimizing Copper Filling Process For Through Silicon Via (TSV)

Through silicon via copper electrodeposition for 3D integration