Abstract:A new method is proposed to investigate the measurement variation of instruments and their ability to discriminate two TA6V surfaces obtained by grinding with SiC grit papers (80 and 120). Three optical measurement technologies included into a single apparatus, namely Confocal Microscopy (CM), Focus Variation (FV) and Coherence Scanning Interferometry (CSI), were used to measure both ground surfaces according to a specific experimental protocol (MorphoMeca Monitoring) based on measurement iterations and repetitions. From the measurements, four indices were built from the Sa roughness parameter to assess the Quality (ratio of the topographical variability over the measurement noise), the Drift (related to surface fluctuations) and the Stability (estimation of the temporal drift using a second order autoregressive model) of the three measurement technologies (modes), as well as their Relevance (computed from an analysis of variance) to discriminate ground surfaces with close roughness. For these investigated surfaces, it was especially highlighted that the Quality Index is four times higher for the CSI mode than for the FV and CM modes. All the used measurement modes experienced small drifting (Drift Index) during the measurements. The CSI mode was slightly more sensitive to drift than the FV and CM modes. The Stability Index indicated that there was no memory effect between two acquisitions for each measurement mode, i.e., the temporal drift did not depend on the measurement mode. Moreover, the three measurement modes are able to discriminate the two ground surfaces with the same accuracy through the Sa parameter. However, the Sa values may vary depending on the measurement modes, and it was finally shown that the Sa parameter is minimized by 0.03 μm for the FV mode compared with the CSI mode, due to its smoothing effect.

Application of incoherence diffraction for inspection of surface roughness

A Measurement System for the Roughness of Ultra Smooth Surface with Large Aperture

Surface defects evaluation system based on electromagnetic model simulation and inverse-recognition calibration method

Method of In-Process Measurement of Wafer Surface Quality Based on Laser Scattering Principle

Roughness Characterization of Well-Polished Surfaces by Measurements of Light Scattering Distribution

Two-dimensional Surface Profile Imaging Technique Based on a Double-Grating Frequency Shifter

Single-Shot White-Light Dispersive Interferometric Profilometer

Distortion Correction in Surface Defects Evaluating System of Large Fine Optics

A new optical technique for roughness measurement on moving surface

Surface Roughness Measurement Based On Image Processing And Image Recognition

Application Of An Adaptive Two-Wave Mixing Interferometer For Detection Of Surface Defects

Non-Contact Surface Roughness Measurement by Implementation of a Spatial Light Modulator

Inspection of diamond turning process by the combination of light scattering and angular deflection techniques: a proposed method

Research on New Technology of Surface Roughness Measurement

A novel methodology to assess optical profilometer stability to discriminate surface roughness

Robust and Objective Automatic Optical Surface Inspection Using Modulated Dark Field Phasing Illumination

Nanoscale surface roughness measurement based on frequency-domain interferometry principle

Development Of User-Friendly Software For The Roughness Measurement Of Ultra Smooth Surface

Real Time Measurement of Surface Roughness Using Laser Technique

Double-grating diffraction interferometric stylus probing system for surface proﬁling and roughness measurement

Light Scattering For Testing Roughness Of Formed Surfwees