Abstract:In this article, an enhanced class-F voltage-controlled oscillator (VCO) with common-mode-noise self-cancellation (CM-NC) and common-mode-noise isolation (CM-NI) technique is proposed. With the proposed CM-NC technique, the common-mode-noise current of the drain coil and that of the nearby source coil are in the opposite direction. Therefore, the magnetic fields generated by the two coils cancel each other, which reduces the noise injected into the VCO from power supply and the ground node. Moreover, the principle of decoupling between the two inductors is also employed to eliminate the influence of the common-mode tail inductor on the differential mode. By winding the gate coil into a double-turn structure, the coupling noise from the drain inductor to the gate is opposite to the induced current of the gate coil, thereby cutting off the noise coupling path from the drain to the gate. Thanks to the dual-core 8-shaped inductor structure, the phase noise (PN) is improved without increasing the area, compared with existing methods using separated and dedicated tail filtering inductors. The VCO is fabricated in a 65-nm complementary metal–oxide–semiconductor (CMOS) technology. The measured tuning range is 21.7% from 11.5 to 14.3 GHz. The PN and figure of merit (FoM) at 1-MHz offset are $-$ 119.2 and 192.8 dBc/Hz, respectively. The power consumption across the frequency tuning range is 5.6–10 mW. The core area is 0.065 mm $^{2}$ and the total area is 0.26 mm $^{2}$ .

A Constant-Current-Controlled Class-C Voltage-Controlled Oscillator Using Self-Adjusting Replica Bias Circuit

A Constant-Current-controlled Class-C VCO Using a Self-Adjusting Replica Biasing Scheme

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A 92 Fsrms Jitter Frequency Synthesizer Based on a Multicore Class-C Voltage-Controlled Oscillator with Digital Automatic Amplitude Control

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A Ka-Band Class-C BiCMOS VCO with Temperature Compensation

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A Tail-Current Modulated VCO with Adaptive-Bias Scheme

A 1mW 5GHz current reuse CMOS VCO with low phase noise and balanced differential outputs

A Tail-Feedback VCO with Self-Adjusting Current Modulation Scheme

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

Design of CMOS Based LC-Voltage Control Oscillator Using Substrate Bias Effect and Current Mirror Technique

Low Phase Noise and Linear Gain VCO Using Self-Switched Biasing

A Complementary Oscillator Using a Current-Limiting Tail Resistor in 180nm CMOS

A 2.4-Ghz Linear-Tuning CMOS LC Voltage-Controlled Oscillator

An Enhanced Class-F Dual-Core VCO With Common-Mode-Noise Self-Cancellation and Isolation Technique

An X-Band Dual-Mode Class-C VCO with a 45.27% Tuning Range in 55-Nm CMOS