Abstract:This paper displays a voltage-controlled oscillator (VCO) with high performance implemented in 0.18 μm CMOS. The proposed CMOS VCO adopts a current-reused method, analog coarse and fine tuning mechanisms, and an adaptive overdrive voltage control structure to increase the overall performance, such as the power dissipation, phase noise, and tuning range, and has a robust start-up condition. The current-reused complementary structure with higher transistor transconductances is to save power consumption; the analog coarse and fine tuning mechanisms are to effectively widen the tuning range; and the adaptive overdrive voltage control technique is to change the transconductances of the transistors to improve power consumption by reasonably biasing the gate and body terminals in a class-AB mode to adjust the threshold voltage of the NMOS transistors. The proposed CMOS VCO adopts the class-AB mode to improve the overall performance and the start-up condition. The figure-of-merit (FOM) and FOM with tuning range (FOMT) are used in evaluating the CMOS VCO performance. The measured phase noise at 1 MHz and 10 MHz offsets is –130.34 dBc/Hz and –150.96 dBc/Hz at the 3.38 GHz operating frequency, respectively. The proposed CMOS VCO has a tuning range between 2.85 and 3.62 GHz corresponding to 23.8% for the fifth-generation (5G) wireless communication applications. The proposed CMOS VCO core using a 1.4-V supply consumes 7.5 mW DC power. The FOMs and FOMTs at 1- and 10-MHz offsets are −192.2, −192.8, −199.7, and −200.3 dBc/Hz, respectively, from the 3.38 GHz output frequency.

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A Low- Power CMOS Ring- Based Oscillator Using Current Steering Logic Structure

A Pvt-Robust Feedback Class-C Vco Using an Oscillation Swing Enhancement Technique

A 5‐ghz Low‐phase Noise CMOS VCO with Swing Boosting Technique

A Low-Voltage High-Swing Colpitts Vco With Inherent Tapped Capacitors Based Dynamic Body Bias Technique

A 1mW 5GHz current reuse CMOS VCO with low phase noise and balanced differential outputs

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A HIGH-SWING CLASS-C VCO WITH AMPLITUDE FEEDBACK LOOP FOR LOW PHASE NOISE AND ROBUST START-UP

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A Constant-Current-controlled Class-C VCO Using a Self-Adjusting Replica Biasing Scheme

Class-C VCO with Amplitude Feedback Loop for Robust Start-Up and Enhanced Oscillation Swing

A Feedback Class-C VCO with Robust Startup Condition over PVT Variations and Enhanced Oscillation Swing

An Enhanced Class-F Dual-Core VCO With Common-Mode-Noise Self-Cancellation and Isolation Technique

A Constant-Current-Controlled Class-C Voltage-Controlled Oscillator Using Self-Adjusting Replica Bias Circuit

A Full Swing and Low Power Voltage-Controlled Ring Oscillator

CMOS Voltage-Controlled Oscillator with Complementary and Adaptive Overdrive Voltage Control Structures

A Low Power CMOS VCO Using Inductive-Biasing with High Performance FoM

An Ultra-Wideband VCO Using Digitally Controlled Varactor Arrays in 40-Nm CMOS Technology

A 2ghz Low Power Differentially Tuned CMOS Monolithic LC-VCO