Abstract:This paper displays a voltage-controlled oscillator (VCO) with high performance implemented in 0.18 μm CMOS. The proposed CMOS VCO adopts a current-reused method, analog coarse and fine tuning mechanisms, and an adaptive overdrive voltage control structure to increase the overall performance, such as the power dissipation, phase noise, and tuning range, and has a robust start-up condition. The current-reused complementary structure with higher transistor transconductances is to save power consumption; the analog coarse and fine tuning mechanisms are to effectively widen the tuning range; and the adaptive overdrive voltage control technique is to change the transconductances of the transistors to improve power consumption by reasonably biasing the gate and body terminals in a class-AB mode to adjust the threshold voltage of the NMOS transistors. The proposed CMOS VCO adopts the class-AB mode to improve the overall performance and the start-up condition. The figure-of-merit (FOM) and FOM with tuning range (FOMT) are used in evaluating the CMOS VCO performance. The measured phase noise at 1 MHz and 10 MHz offsets is –130.34 dBc/Hz and –150.96 dBc/Hz at the 3.38 GHz operating frequency, respectively. The proposed CMOS VCO has a tuning range between 2.85 and 3.62 GHz corresponding to 23.8% for the fifth-generation (5G) wireless communication applications. The proposed CMOS VCO core using a 1.4-V supply consumes 7.5 mW DC power. The FOMs and FOMTs at 1- and 10-MHz offsets are −192.2, −192.8, −199.7, and −200.3 dBc/Hz, respectively, from the 3.38 GHz output frequency.

A Pvt-Robust Feedback Class-C Vco Using an Oscillation Swing Enhancement Technique

A Feedback Class-C VCO with Robust Startup Condition over PVT Variations and Enhanced Oscillation Swing

Class-C VCO with Amplitude Feedback Loop for Robust Start-Up and Enhanced Oscillation Swing

A HIGH-SWING CLASS-C VCO WITH AMPLITUDE FEEDBACK LOOP FOR LOW PHASE NOISE AND ROBUST START-UP

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A 3.7-Mw $K$ -Band Dual-Feedbacks VCO Employing a Self-Inversed Transformer with 190-Dbc/hz FOM

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

An Inverted Complementary Cross-Coupled VCO to Reduce Phase Noise Sensitivity to KVCO

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A Low-Voltage High-Swing Colpitts Vco With Inherent Tapped Capacitors Based Dynamic Body Bias Technique

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A 24ghz Low Phase Noise Feedback Cmos Lc-Vco

A Tail-Feedback VCO with Self-Adjusting Current Modulation Scheme

An Enhanced Class-F Dual-Core VCO With Common-Mode-Noise Self-Cancellation and Isolation Technique

A 5‐ghz Low‐phase Noise CMOS VCO with Swing Boosting Technique

CMOS Voltage-Controlled Oscillator with Complementary and Adaptive Overdrive Voltage Control Structures

A 67.4–71.2-Ghz Nmos-Only Complementary VCO with Buffer-Reused Feedback Technique

A Low Phase Noise and High Linearity Class-C VCO for FMCW Radar System

A Tail-Current Modulated VCO with Adaptive-Bias Scheme