Abstract:The rapid development of the next-generation high-speed wireless communication system has set increasingly stringent requirements on the spectral purity of local RF oscillators. Low phase noise is crucial to support advanced modulation scheme enabling high data-rates wireless link [1]. A viable popular approach is to coupled N identical oscillators together to improve the phase noise by 10log <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">10</inf> N at the cost of N times higher power [2]–[6]. Nevertheless, the coupling network needs to be designed carefully to avoid undesired multi-tone concurrent oscillations. Besides, area occupation is another issue of multi-core VCOs. The star-geometry as shown in Fig. 1. (bottom left), which is simple N times duplication of single core, occupies N times larger area so comes with an area penalty [3]–[5]. To solve this problem, circular geometry is proposed where the passives are merged into a single passive structure and the minimal realizable inductance is reduced while keeping a high Q factor [6]–[7]. In order to further reduce the silicon area, a square-geometry quad-core oscillator with inductor sharing technique is proposed in this paper and it exhibits a compact area of 0.09 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> , which is the smallest quad-core VCO operating at a similar oscillation frequency. The unwanted mode is suppressed by the metal trace that connects the drain node of adjacent cores. Thanks to the proposed square-geometry and inductor sharing technique, the proposed quad-core class-F VCO can further reduce the area occupation. The proposed VCO is fabricated in 65nm CMOS technology. The measured phase noise is -137.2 dB/Hz at 10 MHz offset frequency from a carrier of 19 GHz, which translates to the FoM of 186.1 dBc/Hz.

A HIGH-SWING CLASS-C VCO WITH AMPLITUDE FEEDBACK LOOP FOR LOW PHASE NOISE AND ROBUST START-UP

Class-C VCO with Amplitude Feedback Loop for Robust Start-Up and Enhanced Oscillation Swing

A Feedback Class-C VCO with Robust Startup Condition over PVT Variations and Enhanced Oscillation Swing

A Pvt-Robust Feedback Class-C Vco Using an Oscillation Swing Enhancement Technique

An Inverted Complementary Cross-Coupled VCO to Reduce Phase Noise Sensitivity to KVCO

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A Low Phase Noise V-Band 40 Nm Cmos Phase Locked Loop For Wireless Communication

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A 5‐ghz Low‐phase Noise CMOS VCO with Swing Boosting Technique

A 24ghz Low Phase Noise Feedback Cmos Lc-Vco

A Low Phase Noise and High Linearity Class-C VCO for FMCW Radar System

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

A Class-C Eight-Phase Voltage-Controlled Oscillator With 184.2 dBc/Hz FoM and Loop-Based Superharmonic Coupling in 65nm CMOS

Analysis and design of a new low‐phase noise and Gm‐enhanced class‐C quadrature VCO

An Ultra-Low Phase Noise 1.6ghz 65nm Class-B RF-VCO with -139.44Dbc/hz @1mhz Offset

A Uniform Phase Noise QVCO with a Feedback Current Source

A Low-Phase-Noise Quad-Core Millimeter-Wave Fundamental VCO Using Circular Triple-Coupled Transformer in 65-Nm CMOS

A 68.1-to-73.8ghz E-band Low Phase Noise QPLL with Amplifier Feedback QVCO in 65-Nm CMOS