Abstract:This brief presents a low phase noise class-C voltage-controlled oscillator with bond wire inductors. To improve the Q-factor of inductors, the voltage-controlled oscillator employs bond wires as the inductors of the resonators. A transient-analysis-compatible equivalent circuit is proposed to precisely estimate the influence of mutual inductance, parasitic components and silicon substrate. Possible phenomena of oscillation mode ambiguity and oscillation failure are analyzed to be relative with the magnetic coupling between bond wires. An equation is derived to set up the relation among oscillation mode, bond wire coupling and frequency ratio of adjacent oscillators. And a costless placement reorder method is proposed to prevent the oscillator cores from oscillating failure and mode ambiguity. The voltage-controlled oscillator is implemented in a 65-nm CMOS process. Ten groups of gold double bond wires with a 20 $\mu \text{m}$ diameter, 70 $\mu \text{m}$ height and 800 $\mu \text{m}$ horizontal length are adopted as the inductors. The total tuning range of the oscillator is from 2.22 GHz to 4.46 GHz. When oscillating at 4.46 GHz and the output frequency divide ratio is 2, the output signal provides phase noise performance of −137.3 dBc/Hz at 1 MHz offset from 2.23 GHz. The maximum power consumption is 38 mW and each oscillator core occupies a chip area of only 0.112 mm 2 .

A Low Phase Noise and High Linearity Class-C VCO for FMCW Radar System

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

An Inverted Complementary Cross-Coupled VCO to Reduce Phase Noise Sensitivity to KVCO

Transformer-Based Ultra-Wide Band 43 GHz VCO in 28 nm CMOS for FMCW Radar System

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

Design of a LC-VCO in 65 Nm CMOS Technology for 24ghz FMCW Radar Transceiver

A broadband CMOS LC voltage-controlled oscillator for FMCW synthesizer

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A 2.34–3.29GHz CMOS LC VCO with low phase noise and low power

A 4.2-5 GHz, Low Phase Noise LC-VCO with Constant Bandwidth and Small Tuning Gain

A 6 GHz Wideband Low-phase-noise CMOS LC VCO

Design of a 24GHz low phase-noise,wide tuning-range VCO with optimized switches in capacitor array and bias filtering technique

A 5-8 GHz Wideband and Low Phase Noise Cross-Coupled LC VCO Using 6-bit DCCA in 40nm CMOS Process

A monolithic K-band phase-locked loop for microwave radar application*

A 3.01–3.82 GHz CMOS LC Voltage-Controlled Oscillator with 6.29% VCO-gain Variation for WLAN Applications

Range Resolution Improvement in FMCW Radar Through VCO's Nonlinearity Compensation

A 2.9 GHz Variable Inductor-Based DCO with 1.3 Khz Frequency Resolution for FMCW Radar Applications

A 418 GHz CMOS Fully Integrated LC Balanced Oscillator with Symmetrical Noise Filter Technique and Large Tuning Range

Ultra wideband VHF CMOS LC VCO