Design of low power and low phase noise LC-VCO for Bluetooth/WLAN applications
Kusuma Neerugatti,Venugopal Pakala
DOI: https://doi.org/10.1016/j.aeue.2024.155227
IF: 3.169
2024-03-20
AEU - International Journal of Electronics and Communications
Abstract:The proposed Inductor-Capacitor Voltage-Controlled Oscillator (LC-VCO) prototype design generates 2.45 GHz to 4.58 GHz of frequency using the Cadence UMC 180 nm process with a 1.8V supply. This architecture carried a new viewpoint on tank design put forth by enhancing the varactor tuning. Here, the circuit employs a CMOS differential cross-coupled pair, and rail-to-rail DC biasing achieves a higher voltage swing. Simulation analysis parameters are measured at 2.45 GHz frequency, phase noise is −123.5 dBc/1 MHz offset, power is 3.5 mW, jitter is 0.232 fsec, and it occupies 0.118 μ m 2 layout area. Additionally, the simulations have been extended for analysis under Process Voltage and Temperature Corners, Monte-Carlo, and Worst-Case Corners. This study obtained a better FoM of -200.94 dBc/Hz. The simulation results and FoM of the proposed design show a considerably improved than state-of-the-art framework. This LC-VCO circuit study will be suitable for implementing the sub-6 GHz charge pump phase-locked loops (CP-PLLs) system for 5G applications.
telecommunications,engineering, electrical & electronic