Abstract:This paper displays a voltage-controlled oscillator (VCO) with high performance implemented in 0.18 μm CMOS. The proposed CMOS VCO adopts a current-reused method, analog coarse and fine tuning mechanisms, and an adaptive overdrive voltage control structure to increase the overall performance, such as the power dissipation, phase noise, and tuning range, and has a robust start-up condition. The current-reused complementary structure with higher transistor transconductances is to save power consumption; the analog coarse and fine tuning mechanisms are to effectively widen the tuning range; and the adaptive overdrive voltage control technique is to change the transconductances of the transistors to improve power consumption by reasonably biasing the gate and body terminals in a class-AB mode to adjust the threshold voltage of the NMOS transistors. The proposed CMOS VCO adopts the class-AB mode to improve the overall performance and the start-up condition. The figure-of-merit (FOM) and FOM with tuning range (FOMT) are used in evaluating the CMOS VCO performance. The measured phase noise at 1 MHz and 10 MHz offsets is –130.34 dBc/Hz and –150.96 dBc/Hz at the 3.38 GHz operating frequency, respectively. The proposed CMOS VCO has a tuning range between 2.85 and 3.62 GHz corresponding to 23.8% for the fifth-generation (5G) wireless communication applications. The proposed CMOS VCO core using a 1.4-V supply consumes 7.5 mW DC power. The FOMs and FOMTs at 1- and 10-MHz offsets are −192.2, −192.8, −199.7, and −200.3 dBc/Hz, respectively, from the 3.38 GHz output frequency.

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

A 1mW 5GHz current reuse CMOS VCO with low phase noise and balanced differential outputs

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A Constant-Current-controlled Class-C VCO Using a Self-Adjusting Replica Biasing Scheme

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A 2.15–6.18 GHz transformer-based dual-mode LC-VCO with current-reuse technology

A Tail-Current Modulated VCO with Adaptive-Bias Scheme

A Constant-Current-Controlled Class-C Voltage-Controlled Oscillator Using Self-Adjusting Replica Bias Circuit

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

CMOS Voltage-Controlled Oscillator with Complementary and Adaptive Overdrive Voltage Control Structures

An Enhanced Class-F Dual-Core VCO With Common-Mode-Noise Self-Cancellation and Isolation Technique

A Feedback Class-C VCO with Robust Startup Condition over PVT Variations and Enhanced Oscillation Swing

A Bulk Bias 1V 5GHz Low Power LC VCO with transconductance stabilization

A Pulse-Driven LC-VCO with a Figure-of-merit of &Amp;#x2212;192dbc/hz

A Complementary Oscillator Using a Current-Limiting Tail Resistor in 180nm CMOS

A Low Power CMOS VCO Using Inductive-Biasing with High Performance FoM

A 31–46 GHz Dual-Core Class-C VCO Using Switchable Transformers in 28-Nm CMOS

Low Phase Noise and Linear Gain VCO Using Self-Switched Biasing