Abstract:This paper investigates an adaptive body biasing (ABB) circuit to improve the reliability and variability of a low-voltage inductor-capacitor (LC) voltage-controlled oscillator (VCO). The ABB circuit provides VCO resilience to process variability and reliability variation through the threshold voltage adjustment of VCO's transistors. Analytical equations considering the body bias effect are derived for the most important relations of the VCO and then the performance is verified using the post-layout simulation results. Under a 0.16% threshold voltage shift, the sensitivity of the normalized phase noise and transconductance of the VCO with the ABB circuit compared to the constant body bias (CBB) decreases by around 8.4 times and 3.1 times, respectively. Also, the sensitivity of the normalized phase noise and transconductance of the proposed VCO under 0.16% mobility variations decreases by around 1.5 times and 1.7 times compared to the CBB, respectively. The robustness of the VCO is also examined using process variation analysis through Monte Carlo and corner case simulations. The post-layout results in the 180 nm CMOS process indicate that the proposed VCO draws a power consumption of only 398 µW from a 0.6 V supply when the VCO frequency is 2.4 GHz. It achieves a phase noise of -123.19 dBc/Hz at a 1 MHz offset and provides a figure of merit (FoM) of -194.82 dBc/Hz.

A Tail-Current Modulated VCO with Adaptive-Bias Scheme

A Tail-Feedback VCO with Self-Adjusting Current Modulation Scheme

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A Constant-Current-controlled Class-C VCO Using a Self-Adjusting Replica Biasing Scheme

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

An Inverted Complementary Cross-Coupled VCO to Reduce Phase Noise Sensitivity to KVCO

A Constant-Current-Controlled Class-C Voltage-Controlled Oscillator Using Self-Adjusting Replica Bias Circuit

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A Ka-Band Class-C BiCMOS VCO with Temperature Compensation

A Feedback Class-C VCO with Robust Startup Condition over PVT Variations and Enhanced Oscillation Swing

A Swing-Enhanced Current-Reuse Class-C VCO with Dynamic Bias Control Circuits

A Low Noise VCO with Common-Tail Inductor in 180nm CMOS Technology

A Low Power CMOS VCO Using Inductive-Biasing with High Performance FoM

Design and Analysis of a Low-Voltage VCO: Reliability and Variability Performance

A Pvt-Robust Feedback Class-C Vco Using an Oscillation Swing Enhancement Technique

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A Complementary Oscillator Using a Current-Limiting Tail Resistor in 180nm CMOS

Class-C VCO with Amplitude Feedback Loop for Robust Start-Up and Enhanced Oscillation Swing

Low Phase Noise and Linear Gain VCO Using Self-Switched Biasing

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer