Abstract:This brief presents a low phase noise class-C voltage-controlled oscillator with bond wire inductors. To improve the Q-factor of inductors, the voltage-controlled oscillator employs bond wires as the inductors of the resonators. A transient-analysis-compatible equivalent circuit is proposed to precisely estimate the influence of mutual inductance, parasitic components and silicon substrate. Possible phenomena of oscillation mode ambiguity and oscillation failure are analyzed to be relative with the magnetic coupling between bond wires. An equation is derived to set up the relation among oscillation mode, bond wire coupling and frequency ratio of adjacent oscillators. And a costless placement reorder method is proposed to prevent the oscillator cores from oscillating failure and mode ambiguity. The voltage-controlled oscillator is implemented in a 65-nm CMOS process. Ten groups of gold double bond wires with a 20 $\mu \text{m}$ diameter, 70 $\mu \text{m}$ height and 800 $\mu \text{m}$ horizontal length are adopted as the inductors. The total tuning range of the oscillator is from 2.22 GHz to 4.46 GHz. When oscillating at 4.46 GHz and the output frequency divide ratio is 2, the output signal provides phase noise performance of −137.3 dBc/Hz at 1 MHz offset from 2.23 GHz. The maximum power consumption is 38 mW and each oscillator core occupies a chip area of only 0.112 mm 2 .

A Class-C LC VCO for 802.11 B/g/n and Bluetooth

A Class-C Lc Vco For 802.11 Bigin And Bluetooth

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Ka-Band Class-C BiCMOS VCO with Temperature Compensation

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

Design of low power and low phase noise LC-VCO for Bluetooth/WLAN applications

8.64-11.62 Ghz Cmos Vco And Divider In A Zero-If 802.11a/B/G Wlan And Bluetooth Application

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

An Enhanced 4.8-Ghz Fully Integrated NMOS LC VCO for Wireless LAN Application

Design of Frequency Doubling VCO for Bluetooth Transceiver

A 5ghz Cmos Vco For Ieee 802.11a Wlan Application

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer

A 4.2-5 GHz, Low Phase Noise LC-VCO with Constant Bandwidth and Small Tuning Gain

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A current-reuse Class-C LC-VCO with an adaptive bias scheme

A 5.6∼8.2ghz QVCO with a New DCCA Circuit

A 3.01–3.82 GHz CMOS LC Voltage-Controlled Oscillator with 6.29% VCO-gain Variation for WLAN Applications

An Ultra-Wideband VCO Using Digitally Controlled Varactor Arrays in 40-Nm CMOS Technology