Abstract:Low-temperature sintering of cordierite ceramic depends on the phase transformation into cordierite and the properties depend on its microstructure. In the present work, the effect of cerium on the phase transformation and microstructure of cordierite ceramics prepared by sol-gel method is studied by X-ray diffraction (XRD), differential thermal analysis (DTA) and scanning electron microscopy (SEM) in order to lower the sintering temperature and improve the properties of cordierite ceramic with the addition of cerium. It is observed that the cerium addition obviously lowers the crystallization temperature of α-cordierite while slightly raises that of μ-cordierite. The lowest temperature for μ → α cordierite transformation, which approaches the crystallization temperature of μ-cordierite, is achieved in the sample containing 4 wt% of cerium, implying a possibility to lower the sintering temperature of cordierite ceramics. The Ce-contained ceramics show a biphasic microstructure that is dependent on sintering temperature. Sintered below 1300°C, a cordierite-CeO 2 microstructure is present; while sintered at the temperature above 1300°C, appears a cordierite-glass microstructure, of which the amount of glass phase is limited to a small extent. Since the addition of 4 wt% cerium to this MgO-Al 2 O 3 -SiO 2 system substantially enhances the densification of cordierite ceramics and lowers the sintering temperature to the level of around 1000°C, it makes the ceramics suitable for such applications, where the low-temperature sintering is required, as the substrates for electronic circuit and the catalytic supports (with oxygen storage capacity) for cleaning of automotive exhaust emissions.

Preparation and Characterization of Cordierite Powder Via Tween-80 Modified Citrate Sol-Gel Method

Preparation and characterization of cordierite powders by water-based sol-gel method

Study on the Preparation of Flake Cordierite Powder

Preparation of Cordierite Powder by Chemical Coprecipitation–rotation Evaporation and Solid Reaction Sintering

Factors affecting crystallization behavior of cordierite by Sol-gel

Microstructural analysis on cordierite ceramics prepared by sol-gel

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Utilization of Sepiolite in the Synthesis of Porous Cordierite Ceramics

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

Effect of Mineral Composition and Sintering Temperature on the Synthetic Cordierite

Effect of the citrate sol–gel synthesis on the formation of MgAl2O4 ultrafine powder

Mechanism of Cordierite Formation Obtained by High Temperature Sintering Technique

Preparation of macroporous cordierite monoliths via the sol-gel process accompanied by phase separation

Effects of formulation and temperature on synthesis of cordierite from serpentine

Effect of Cerium Addition on Phase Transformation and Microstructure of Cordierite Ceramics Prepared by Sol-Gel Method

Crystallization Kinetics, Properties of Α-Cordierite Based Glass-ceramics Prepared by Glass Powder Sintering

Crystallization behavior and properties of cordierite synthesized by sol-gel technique and hydrothermal treatment

In-situ synthesis and properties of porous cordierite ceramics with adjustable pore structure

Preparation of Rare Earth/Alkaline Earth Composite Silicates Nanopowder by Water-Based Sol-Gel Method

Microstructural Development on Sol–gel Derived Cordierite Ceramics Doped B2O3 and P2O5

Preparation and Characterization of Citrate Sol-Gel Derived Ba(Zr,Ti)O3 Ceramics with Al2O3 Addition