Abstract:Cordierite glass-ceramics usually begin to crystallize from the surface. As an efficient nucleating agent, TiO2 can promote the rapid transformation of glass to bulk crystallization, but it is easy to cause the increase of dielectric constant and light absorption. High crystallinity cordierite glass-ceramics were prepared by optimizing the heat treatment process without or with different nucleating agents in stoichiometric cordierite glasses. The results show that the crystallization mechanisms of glasses without and with ZrO2+P2O5 as nucleation agents are controlled by surface crystallization. While, the glass with TiO2+ZrO2+P2O5 as nucleation agents have the tendency to be bulk crystallization. The studied glasses are crystallized from surface and have different crystallization orientations with the inner glass. The thickness of crystalline layer increased with the increasing of heating temperatures, but the "surface-center" crystallization process cannot complete by further increasing heating temperatures because of softening deformation of glasses. At 1020 ℃, the glasses complete the "surface-center" crystallization for long durations. The glasses without nucleation agents and with ZrO2+P2O5 require 10 h, but the glass with TiO2+ZrO2+P2O5 complete for 5 h. Although all the three glasses complete the "surface-center" crystallization, the glasses with nucleation agents show the higher crystallinity upon the same heat treatments. Finally, glass-ceramics with excellent performance were obtained, for example, the Z1# glass-ceramic have the high microhardness ∼7.4 GPa, low thermal expansion coefficient ∼1.4☓10−6 ℃-1 at 20–300 ℃, and relatively high thermal conductivity ∼2.4 W/mK. It also exhibits low dielectric constant and loss, which was ∼4.5 and ∼1.2☓10-3 at 1 MHz, ∼ 4.9 and 2.3☓10-3 at 10.5 GHz..

Factors affecting crystallization behavior of cordierite by Sol-gel

Crystallization behavior and properties of cordierite synthesized by sol-gel technique and hydrothermal treatment

Preparation and characterization of cordierite powders by water-based sol-gel method

Microstructural analysis on cordierite ceramics prepared by sol-gel

Crystallization Kinetics, Properties of Α-Cordierite Based Glass-ceramics Prepared by Glass Powder Sintering

Study on the Preparation of Flake Cordierite Powder

Crystallization and Dielectric Properties of Cordierite Gel-Derived Glasses Containing B2O3and P2O5

Effect of Mineral Composition and Sintering Temperature on the Synthetic Cordierite

Sintering characteristics and crystallization for sol–gel-derived powders for low-dielectric and low-temperature sintering ceramics

Microstructural Development on Sol–gel Derived Cordierite Ceramics Doped B2O3 and P2O5

Preparation and Characterization of Cordierite Powder Via Tween-80 Modified Citrate Sol-Gel Method

Mechanism of Cordierite Formation Obtained by High Temperature Sintering Technique

Effect of Cerium Addition on Phase Transformation and Microstructure of Cordierite Ceramics Prepared by Sol-Gel Method

Preparation of macroporous cordierite monoliths via the sol-gel process accompanied by phase separation

Preparation of Cordierite Powder by Chemical Coprecipitation–rotation Evaporation and Solid Reaction Sintering

MgO-Al<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub> Glass-Ceramic Prepared by Sol-Gel Method

Effect Of Ph Value On Sintering Behaviors Of Cordierite Glass Ceramics Synthesized By Sol-Gel

Effects of formulation and temperature on synthesis of cordierite from serpentine

Effect of Excess MgO on the Properties of Cordierite Ceramic Sintered by Solid‐State Method

Synthesis, characterization, and sintering of sol–gel derived cordierite ceramics for high-frequency MLCIs

Crystallization mechanisms of cordierite glass-ceramics with “surface-center” crystallization behavior