Abstract:Low-temperature sintering of cordierite ceramic depends on the phase transformation into cordierite and the properties depend on its microstructure. In the present work, the effect of cerium on the phase transformation and microstructure of cordierite ceramics prepared by sol-gel method is studied by X-ray diffraction (XRD), differential thermal analysis (DTA) and scanning electron microscopy (SEM) in order to lower the sintering temperature and improve the properties of cordierite ceramic with the addition of cerium. It is observed that the cerium addition obviously lowers the crystallization temperature of α-cordierite while slightly raises that of μ-cordierite. The lowest temperature for μ → α cordierite transformation, which approaches the crystallization temperature of μ-cordierite, is achieved in the sample containing 4 wt% of cerium, implying a possibility to lower the sintering temperature of cordierite ceramics. The Ce-contained ceramics show a biphasic microstructure that is dependent on sintering temperature. Sintered below 1300°C, a cordierite-CeO 2 microstructure is present; while sintered at the temperature above 1300°C, appears a cordierite-glass microstructure, of which the amount of glass phase is limited to a small extent. Since the addition of 4 wt% cerium to this MgO-Al 2 O 3 -SiO 2 system substantially enhances the densification of cordierite ceramics and lowers the sintering temperature to the level of around 1000°C, it makes the ceramics suitable for such applications, where the low-temperature sintering is required, as the substrates for electronic circuit and the catalytic supports (with oxygen storage capacity) for cleaning of automotive exhaust emissions.

Synthesis, characterization, and sintering of sol–gel derived cordierite ceramics for high-frequency MLCIs

Microstructural Development on Sol–gel Derived Cordierite Ceramics Doped B2O3 and P2O5

Microstructural analysis on cordierite ceramics prepared by sol-gel

Sintering and crystallization of cordierite glass ceramics for high frequency multilayer chip inductors

Sintering characteristics and crystallization for sol–gel-derived powders for low-dielectric and low-temperature sintering ceramics

Sol-gel preparing process and properties of cordierite powders used for high frequency chip inductors

Preparation and characterization of cordierite powders by water-based sol-gel method

Synthesis of Cordierite Powders by Low Temperature Combustion Method

Sintering Mechanism and Properties of Cordierite Ceramics Used for High Frequency Chip Inductors

Low-Temperature Combustion Synthesis of Cordierite Powder and Its Characteristic

Crystallization and Dielectric Properties of Cordierite Gel-Derived Glasses Containing B2O3and P2O5

Low firing temperature ceramic material for high frequency multilayer chip inductors

Effect of Bi2O3 on Sintering and Dielectric Properties of Cordierite Ceramics Synthesized by Sol-Emulsion-Gel Technique

Effect of Cerium Addition on Phase Transformation and Microstructure of Cordierite Ceramics Prepared by Sol-Gel Method

Aspects of development and properties of densely sintered of ultra-high-frequency radio-transparent ceramics of cordierite composition

Low-Temperature Combustion Synthesis of Cordierite Powder and Its Properties

Low-T Sintering, Low-Dielectric Materials for High Frequency Multilayer Chip Inductors

Low-Temperature Combustion Synthesis of Cordierite Ceramic Powder

Mechanism of Cordierite Formation Obtained by High Temperature Sintering Technique

The Influence of Li+ on the Sintering of Cordierite Glass Ceramic

In-situ synthesis and properties of porous cordierite ceramics with adjustable pore structure