Abstract:The micro-texture is a relatively well-established method for improving the tribological performance of Co-Cr-Mo alloy. Currently, to fabricate the micro-textures on the alloy surface, laser micromachining technology is the commonly used method. However, the low fabrication quality (such as irregular protrusions inside and on the edges of the micro-textures) caused by laser ablation limits the numerous application of laser surface textures. Therefore, a novel method of combining nanosecond (ns) pulse laser texturing with ion beam etching was proposed to prepare the micro-textures on the surface of Co-Cr-Mo alloy. The tribological properties before and after ion beam etching were tested by ball-disk friction wear test for three different micro-texture morphologies (grooved micro-texture (G); hexagonal micro-texture (H); concentric micro-texture (C)), and the micro-topography, mechanical properties and wettability of the ion beam/laser textured Co-Cr-Mo alloy were also investigated. The results showed that the friction coefficient and wear amount of the specimen surface were reduced after ion beam etching, and the ion beam/laser textured sample with hexagonal micro-textures showed the best wear performance, with the average friction coefficient reduced by 11.9 % and the wear amount of polyether ether ketone balls reduced by 14.9 %. The worn surface of the ion beam etched samples was relatively smooth, and the adhesive wear was also reduced. This report established the friction reduction model of ion beam/laser textured alloy and revealed the friction reduction mechanism of ion beam etching, providing a new idea of fabricating high-quality micro-textures to enhance the wear performance of artificial hip joints.

Electronic-controlling Nanotribological Behavior of Textured Silicon Surfaces Fabricated by Laser Interference Lithography

Investigations in the fabrication of surface patterns for wettability modification on a Zr-based bulk metallic glass by nanosecond laser surface texturing

Controllable Diamond Cutting of Structured Surfaces with Subnanometric Height Features on Silicon

AFM Tip-Based Fabrication of Silicon Nanostructures with Reduced Subsurface Amorphous Layers

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Investigation on microtribological behavior of thin films using friction force microscopy

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

An Experimental Investigation of Tribological Performance of Triangular Textures in Water Lubrication Regime

Experimental Study of Tribological Properties of Silicon-Based MEMS/NEMS Surface with Atomic Force Microscope

Effect of picosecond laser texturing on the friction behavior of silicon carbide in hybrid ceramic bearings under dry and water lubrication

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

Investigations on femtosecond laser modified micro-textured surface with anti-friction property on bearing steel GCr15

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Investigating the effect of nanoscale triboelectrification on nanofriction in insulators

Improvement of current-carrying tribological behaviour via laser surface texture

Effect of ion beam etching on the tribological performance of laser textured Co-Cr-Mo alloy

Investigations on femtosecond laser-induced surface modification and periodic micropatterning with anti-friction properties on Ti6Al4V titanium alloy

Characterizing lateral frictional properties on nanostructured periodic surface of Ni fabricated using femtosecond laser pulses

Analysis of synergistic friction reduction effect on micro-textured cemented carbide surface by laser processing

Effect of laser preparation strategy on surface wettability and tribological properties under starved lubrication

Synergistic effect of surface sinusoidal textures and oxide layer on tribological properties of 40Cr alloy steel