Abstract:High-density polyethylene (HDPE) materials have many applications in the municipal solid waste (MSW) landfills. HDPE gravity drainage pipes are commonly utilized in MSW landfills because of the polymer's resistance to harsh chemical conditions. When landfill wastes are freshly filled, the weight acting on the leachate collection pipe increases. The temperature of the leachate collection pipe increases as a result of the heat produced by the decomposition of organic components after waste filling. In this paper, the effects of sequentially applying pressure and elevating temperature on the deformation characteristics (such as deformations and strains) of HDPE pipes are investigated. Measurements of pipe deformations and circumferential strains from model experiments in which 110 mm HDPE pipes were backfilled with sand and subjected to 300 kPa of maximum vertical pressure at temperatures of 20, 60 and 80 °C showed the following results: (1) a classification of pipe behavior relative to the surrounding soil stiffness is advantageous for HDPE pipe design; (2) when temperature increases to 60 °C and 80 °C, the strain distribution around the pipe changes from V-shaped to U-shaped, and the pipe deformation profile changes from elliptical to rectangular; (3) when temperature increases from 20 °C to 60 °C, the vertical and horizontal pipe deflections increase by a factor of 1.08~1.19; (4) when temperature increases from 60 °C to 80 °C, the vertical and horizontal pipe deflections increase by a factor of 1.15~1.31; and (5) the existing analytical method that considers two extreme interfaces can capture the deformations measured in the model test well. In addition, preliminary recommendations for the design of leachate collection pipes are provided based on the analysis of differences in pipe profile versus temperature.

Study on the Allowable Temperature for Preventing Over Welding During Thermal Welding of Polyethylene Pipe

Investigation on the Allowable Temperature During Electrofusion Welding of Polyethylene Pipe

Effect of Butt Fusion Welding Beads on Tensile Properties of Polyethylene Pipes

Applicability Analysis of Thermoplastic Material As Liner Pipe for Trenchless Rehabilitation of Thermal Pipelines

Effect Simulation of Fire Damage to Thermal Performance of High Density Polyethylene Pipe

Simulation of Temperature Field in HDPE Pipe Thermal Welding

Investigation on the hot melting temperature field simulation of HDPE water supply pipeline in gymnasium pool

Accelerated Hydrothermal Aging and Degradation Mechanism of PE100 Butt-Fusion Welded Joint

Failure Analysis on Premature Fracture of Polyethylene Pipe for Floor Heating System

Safety Assessment of High Density Polyethylene Pipe with Thermal Damages

Thermal degradation of PC and PA6 during laser transmission welding

Analysis on Temperature Field in Electrofusion Joint for Polyethylene Pipes

A Model for Predicting Temperature of Electrofusion Joints for Polyethylene Pipes

Influence of Fire Damage on Mechanical Properties of High Density Polyethylene Pipe Material

High-Density Polyethylene Degradation into Low Molecular Weight Gases at 1823 K: An Atomistic Simulation

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

An experimental‐based thermal prediction model for butt fusion welding of polymer pipes

Investigating the Deformation Characteristics of Buried High-Density Polyethylene Pipes: Considering the Effect of Sequentially Applying Pressure and Elevating Temperature

Role of Melt Plasticizing Temperature in Morphology and Properties of PE100 Pipes Prepared by a Rotational Shear System

Thermal-Mechanical Fatigue Behavior of P92 T-Piece Pipe

Modeling and experiments of the thermal degradation behavior of PMMA during laser transmission welding process