Abstract:High-density polyethylene (HDPE) materials have many applications in the municipal solid waste (MSW) landfills. HDPE gravity drainage pipes are commonly utilized in MSW landfills because of the polymer's resistance to harsh chemical conditions. When landfill wastes are freshly filled, the weight acting on the leachate collection pipe increases. The temperature of the leachate collection pipe increases as a result of the heat produced by the decomposition of organic components after waste filling. In this paper, the effects of sequentially applying pressure and elevating temperature on the deformation characteristics (such as deformations and strains) of HDPE pipes are investigated. Measurements of pipe deformations and circumferential strains from model experiments in which 110 mm HDPE pipes were backfilled with sand and subjected to 300 kPa of maximum vertical pressure at temperatures of 20, 60 and 80 °C showed the following results: (1) a classification of pipe behavior relative to the surrounding soil stiffness is advantageous for HDPE pipe design; (2) when temperature increases to 60 °C and 80 °C, the strain distribution around the pipe changes from V-shaped to U-shaped, and the pipe deformation profile changes from elliptical to rectangular; (3) when temperature increases from 20 °C to 60 °C, the vertical and horizontal pipe deflections increase by a factor of 1.08~1.19; (4) when temperature increases from 60 °C to 80 °C, the vertical and horizontal pipe deflections increase by a factor of 1.15~1.31; and (5) the existing analytical method that considers two extreme interfaces can capture the deformations measured in the model test well. In addition, preliminary recommendations for the design of leachate collection pipes are provided based on the analysis of differences in pipe profile versus temperature.

Investigation on the Allowable Temperature During Electrofusion Welding of Polyethylene Pipe

Study on the Allowable Temperature for Preventing Over Welding During Thermal Welding of Polyethylene Pipe

Effect of Butt Fusion Welding Beads on Tensile Properties of Polyethylene Pipes

Ultrasonic Technique For Testing Cold Welding Of Butt-Fusion Joints In Polyethylene Pipe

Analysis on Temperature Field in Electrofusion Joint for Polyethylene Pipes

A Model for Predicting Temperature of Electrofusion Joints for Polyethylene Pipes

Investigation on the hot melting temperature field simulation of HDPE water supply pipeline in gymnasium pool

Accelerated Hydrothermal Aging and Degradation Mechanism of PE100 Butt-Fusion Welded Joint

Effect Simulation of Fire Damage to Thermal Performance of High Density Polyethylene Pipe

Applicability Analysis of Thermoplastic Material As Liner Pipe for Trenchless Rehabilitation of Thermal Pipelines

Failure Analysis on Premature Fracture of Polyethylene Pipe for Floor Heating System

Mechanical Properties of Butt Weldments Made with Q345B Steel and E5015 Electrodes at Different Temperatures

Simulation of Temperature Field in HDPE Pipe Thermal Welding

Safety Assessment of Cold Welding Defect in Electro-Fusion Joint of Polyethylene Pipe

Investigating the Deformation Characteristics of Buried High-Density Polyethylene Pipes: Considering the Effect of Sequentially Applying Pressure and Elevating Temperature

Mechanical properties of butt weldments made with E5515-G electrodes at high temperature

Safety Assessment of High Density Polyethylene Pipe with Thermal Damages

Development Of Nondestructive Test And Safety Assessment Of Electrofusion Joints For Connecting Polyethylene Pipes

High-Density Polyethylene Degradation into Low Molecular Weight Gases at 1823 K: An Atomistic Simulation

Role of Melt Plasticizing Temperature in Morphology and Properties of PE100 Pipes Prepared by a Rotational Shear System

Ultrasonic Inspection of Welding in Electro-Fusion Joint of Polyethylene Pipes