Abstract:One of the most important limitations of the atomic force microscopy (AFM) is scanning speed, whose high values are required for contemporary high-resolution, long-range diagnostic applications. The measurement bandwidth of an AFM depends on several factors, but usually results from the time constant of the oscillating cantilever, which is correlated with its resonance frequency and quality factor. We propose a method to overcome this problem by performing the surface measurements when the cantilever is vibrating in higher eigenmodes. In this paper we demonstrate the application of active piezoresistive cantilevers operating in this mode. The active piezoresistive cantilever comprises a piezoresistive deflection sensor, a deflection actuator and a nanotip. It is a complete micro-electro-mechanical system (MEMS), ensuring the highest reliability of cantilever vibration control and detection. Higher eigenmode operations are usually difficult to implement as they usually result in lower deflection and lower sensitivity of the probe vibration deflection. Here we present an experimental modification of the structure of an active piezoresistive cantilever using focused ion beam (FIB) machining that mitigates both weaknesses. This has enabled the cantilever to scan the surface at a scanning rate of 10 lines/s with a maximum speed of 500 μm/s and a data acquisition rate of 10 kS/s, when the probe is vibrating at 380 kHz in the second eigenmode. We also describe a traceable calibration routine (based on analysis of the response of the piezoresistive detector, the output of the HeNe interferometer and precise control of the deflection actuator), together with the cantilever modification process and the development of the measurement setup. We show measurement results of dedicated calibration samples and silicon carbide crystal lattice references.

3-Dimensional Piezodriven Microcantilever for Scanning Force Microscope.

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Two-Dimensional Optical Scanning of A Piezoelectric Cantilever Actuator

A piezodriven three dimensional micropositioning stage for nano-manufacturing

A Two-Dimensional Micro Scanner Integrated With A Piezoelectric Actuator And Piezoresistors

Novel high vacuum scanning force microscope using a piezoelectric cantilever and the phase detection method

Flexible Piezoelectric Tactile Sensor Array For Dynamic Three-Axis Force Measurement

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

Compound Three-dimensional Piezoelectric Scanner Used in Scanning Probe Microscopy

3.8×3.8 mm2 Tiny Piezoelectric Resonant MEMS Scanner Using Fork-Shaped and Ring-Shaped Actuators

3.8×3.8 mm2 compact piezoelectric resonant MEMS scanner using fork-shaped and ring-shaped actuators

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Application of active piezoresistive cantilevers in high-eigenmode surface imaging

Three-dimensional atomic force microscopy based on tailored cantilever probe with flared tip

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Study of piezo-induced surface vibration in solids using atomic force probe

Design And Optimization Of Micro Scanner Driven By Folded Piezoelectric Unimorph Actuators Using Pzt Films

Microstructured Cantilever Probe on Optical Fiber Tip for Microforce Sensor

Improvement and Application of Scanning Near Field Optical Microscope Based on A Piezoelectric Bimorph Shear Force Beam

A Silicon-based Scanning Micromirror Actuated by Piezoelectric Cantilevers Using PZT

Design and Control of a Novel 3-D Piezoelectric Scanning Coaxial Optical Microscope System