Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

Finite element model updating of damped structures using vibration test data under base excitation

Model Updating for a Satellite Structure Based on Basic Excitation Test Data

Nonlinear finite element model updating with a decentralized approach

Model Updating Applied to an Missile Structure

Dynamic sensitivity-based finite element model updating for nonlinear structures using time-domain responses

Structural modal identification and MCMC-based model updating by a Bayesian approach

Research on Finite Element Model Updating Technique Based on Static Strength Test

A Method for Updating Damping of Analytical Model of Substructure Based on Frequency Response

Structural Finite Element Model Updating by Using Response Surfaces and Radial Basis Functions

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

New Methods for Finite Element Model Updating Problems

Strain Response Based Finite Element Model Updating by Using Response Surface Method

FINITE ELEMENT MODEL UPDATING AND SAFETY ASSESSMENT OF IN-SERVICE CABLE-MEMBRANE STRUCTURE BASED ON SPATIAL CONFIGURATION

Response-surface based on finite element model updating of bridge structures

The Composite Methods of Updating Finite Element Models

Finite element model updating based on response surface of the truncated singular values of frequency response functions

Model updating of a shear‐wall tall building using various vibration monitoring data: Accuracy and robustness

Finite Element Simulative Computation and Optimal Analysis of Parameters for Reducing Vibration of Complex Damping Structure

Finite element model updating and response prediction of a frame structure based on optimal sensor placement

Substructure-based model updating using residual flexibility mixed-boundary method

Missile Structure Model Updating Based on Nastran Optimization