Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

Dynamic sensitivity-based finite element model updating for nonlinear structures using time-domain responses

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

Nonlinear finite element model updating with a decentralized approach

Dynamic Sensitivity Analysis of Complex Structure Based on FEM

Structural modal identification and MCMC-based model updating by a Bayesian approach

Updating numerical models towards time domain alignment of structural dynamic responses with a limited number of sensors

A Two-Stage Model Updating Method for the Linear Parts of Structures with Local Nonlinearities

Finite element model updating and response prediction of a frame structure based on optimal sensor placement

REVIEW AND ASSESSMENT OF MODEL UPDATING FOR NON-LINEAR, TRANSIENT DYNAMICS

Markov Chain Monte Carlo-based Bayesian method for nonlinear stochastic model updating

Nonlinear model updating of the rotor-bearing system by multi-harmonic balance method and analytical sensitivity derivation

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Design sensitivity analysis of dynamic response of nonviscously damped systems

Model-free Identification of Multiple Periodic Excitations and Detection of Structural Anomaly Using Noisy Response Measurements

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

A Method for Updating Damping of Analytical Model of Substructure Based on Frequency Response

Model updating of dynamic systems with strong nonlinearities using multivalued global correlation analysis

Application of 2D finite element model for nonlinear dynamic analysis of clamp band joint

Time history analysis-based nonlinear finite element model updating for a long-span cable-stayed bridge

Transient Response Sensitivity Analysis of Localized Nonlinear Structure Using Direct Differentiation Method

Finite element model updating based on response surface of the truncated singular values of frequency response functions