Abstract:Modal updating is a crucial problem in Structure Health Monitoring (SHM) and has strongly attracted researchers' attentions. Recently the structures have been becoming much huger and more complex, so it's getting harder to update the global structural model precisely using the classical model updating methods. In general, only some local substructure model is important and it is not necessary to update the whole structure. Therefore the substructure technologies are important for that they require only few sensors and the local dynamic information to accurately update the interested substructure model. Usually the updating of the element stiffness is enough to reflect the damage and the structural dynamic performance. This paper proposes a concept of the Isolated Substructure. It aims at updating local substructure element stiffness only by the relative mode at the substructure location. The present Isolated Substructure refers to a new structure formed by isolating the substructure from the global structure. Then the substructure can be updated indirectly through updating the Isolated Substructure, such that the optimizing variables become much less and the convergent speed is fastened. The key process of this method is to construct the flexibility matrix of the Isolated Substructure by measured data. First the lower order frequencies and shape modes of the substructure are identified from the measured impulse response by utilizing Eigensystem Realization Algorithm (ERA), and the relative modal masses are estimated by Least Square Method (LSM); Second, according to its independence and convergence properties, the flexibility matrix corresponding to the substructure can be approximately constructed by the identified lower order modes and be improved by the calculated higher order modes from the theoretical model; and then utilizing the concept of the flexibility matrix, the substructure is isolated from the global structure through applying numerical supporting on the substructure boundary; synchronously the flexibility matrix of the Isolated Substructure is constructed from the advanced obtained flexibility matrix of the global structure, and is used to update the Isolated Substructure, that is, to equally update the substructure. The optimization method based on sensitivity idea is adopted, and the relative formulas are deduced. It makes the iteration and convergence faster. A numerical example of a plane truss separately with 5% or 10% rms Gaussian measurement error validates that the substructure can be updated effectively by the Isolated Substructure model updating method.

A Method for Updating Damping of Analytical Model of Substructure Based on Frequency Response

Structural modal identification and MCMC-based model updating by a Bayesian approach

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Damping identification using weighted fitting of Frequency-response-function (WFF) method

Dynamic sensitivity-based finite element model updating for nonlinear structures using time-domain responses

Finite element model updating of damped structures using vibration test data under base excitation

A Universal Rate-Dependent Damping Model for Arbitrary Damping-Frequency Distribution

A time-domain method for free vibration responses of an equivalent viscous damped system based on a complex damping model

Model Updating Analysis of Structural Dynamic Problem Based on Multi-Level Weight Coefficients

Physical Essence and Influence of Model Parameters on Dynamic Response of Rayleigh Damping

Adaptive model reduction technique for large-scale dynamical systems with frequency-dependent damping

Efficient and Accurate Method for Calculating the Stochastic Seismic Response of A Nonproportionally Damped Structure

Response Adjustability Analysis of Partial and Ordinary Differential Coupling System for Visco-Elastomer Sandwich Plate Coupled with Distributed Masses under Random Excitation via Spatial Periodicity Strategy

Model updating of lattice structures: A substructure energy approach

Research on the Iterative Method for Model Updating Based on the Frequency Response Function

Substructure-based model updating using residual flexibility mixed-boundary method

Structural Dynamic Model Updating Based on Multi-Level Weight Coefficients

An iterative method for updating finite element models with connectivity constraints

A New Method to Calculate Additional Damping Ratio considering the Effect of Excitation Frequency

ISOLATED SUBSTRUCTURE MODEL UPDATING BASED ON LOCAL MODE

Isolated Substructure Model Updating Based on Local Time Series