Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

New Methods for Finite Element Model Updating Problems

A New Model Updating Method for Quadratic Eigenvalue Problems

A direct method for model updating with incomplete measured data and without spurious modes

An iterative method for updating finite element models with connectivity constraints

Finite element model updating for structural applications

Finite element model updating for repeated eigenvalue structures via the reduced-order model using incomplete measured modes

A New Model Updating Method for Quadratic Eigenvalue Problems. II

Nonlinear finite element model updating with a decentralized approach

The Composite Methods of Updating Finite Element Models

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

Finite Element Model Updating Using Incomplete Sets of Experimental Complex Modes

Research of a model updating method based on matrix approximation theory

Finite element model updating through derivative-free optimization algorithm

Structural modal identification and MCMC-based model updating by a Bayesian approach

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

Robust improvement of the finite-element-model updating of historical constructions via a new combinative computational algorithm

A New Stochastic Model Updating Method Based on Improved Cross-Model Cross-Mode Technique

A Two-Stage Model Updating Method for the Linear Parts of Structures with Local Nonlinearities

Model Updating Method Based on Measurable Information

FE Model Updating Based on Adaptive Response Surface Method

Dynamic sensitivity-based finite element model updating for nonlinear structures using time-domain responses