Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

The Composite Methods of Updating Finite Element Models

A Numerically Stable Dynamic Coefficient Method and Its Application in Free Vibration of Partial-Interaction Continuous Composite Beams

New Methods for Finite Element Model Updating Problems

Finite element model updating method and its application

An iterative method for updating finite element models with connectivity constraints

Robust improvement of the finite-element-model updating of historical constructions via a new combinative computational algorithm

Finite element model updating for structural applications

Nonlinear finite element model updating with a decentralized approach

Fracture Modeling of Curved Composite Shell Structures Using Augmented Finite Element Method

Substructure-based model updating using residual flexibility mixed-boundary method

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

Structural modal identification and MCMC-based model updating by a Bayesian approach

Research of a model updating method based on matrix approximation theory

Finite Element Model Updating Using Incomplete Sets of Experimental Complex Modes

Bridge Model Updating Based on Wavelet Neural Network and Wind-Driven Optimization

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

Finite Element Model Updating in the Vibration of Bladed Disk: Shaft Assemblies

Research on systemic method of dynamic model updating concerning aerospace structural

A Two-Stage Model Updating Method for the Linear Parts of Structures with Local Nonlinearities

Hierarchical Model Updating Strategy of Complex Assembled Structures with Uncorrelated Dynamic Modes

Structural Dynamic Model Updating in High-Temperature Environment Based on a Two-Stage Modification