Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

Finite element model updating method and its application

Finite Element Model of Milling Process Sequence for Frame Monolithic Components

Key Technologies of Physics-Based Milling Process Simulation

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

The Composite Methods of Updating Finite Element Models

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Stiffness Analysis of Machine Tools Using Finite Element Method

Finite element model updating method for continuous girder bridges using monitoring responses and traffic videos

Finite element model updating for structural applications

Bridge finite element model updating using stochastic vehicle-induced static response monitoring data

Finite element model updating through derivative-free optimization algorithm

New Methods for Finite Element Model Updating Problems

Fuzzy finite element model updating using metaheuristic optimization algorithms

Finite element model updating based on response reconstruction using a modified Kalman filter

Finite Element Model Updating Using Response Surface Method

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

Finite Element Model Updating in the Vibration of Bladed Disk: Shaft Assemblies

Frequency Response Function-Based Finite Element Model Updating Using Extreme Learning Machine Model

FE Model Updating Based on Adaptive Response Surface Method