Abstract:The finite element (FE) model updating is a commonly used tool in civil engineering, enabling damage detection, design verification, and load capacity identification. In the FE modelupdating, acceleration responses are generally employed to determine modal properties of a structure, which are subsequently used to update the numerical model. While the acceleration-based model updating has been successful in finding better approximations of the physical systems, the boundary conditions are considered yet to be difficult to accurately estimate as the acceleration responses only correspond to the translational degree-of-freedoms (DOF).Recent advancements in the sensor technology have enabled low-cost, high-precision gyroscopes that can be adopted in the FE modelupdating to provide angular information of a structure. Especially, as the angular DOF is closely related to the rotational stiffness, gyroscopes in the FE model updating would give information of boundary conditions. This study proposes a FE modelupdating strategy based on data fusion of acceleration and angular velocity. The use of acceleration and angular velocity gives richer information than the sole use of acceleration, allowing the enhanced performance particularly in determining the boundary conditions. In this paper, a numerical simulation is presented to demonstrate the proposed FE modelupdating approach using the data fusion. A beam modelled using the Euler-Bernoulli beamelement is consideredwith various boundary conditions (i.e., simply supported, fixed supports, and in between). Optimization variables of the FE model updating are selected to be the elastic modulus and the rotational stiffness of two supports. The proposed FE modelupdating based on acceleration and angular velocityis shown to be able to more accurately identifythe boundary condition than the sole use of acceleration. Consequently, this paper verifies that data fusion of acceleration and angular velocity enhances the performance of the FE modelupdating. Graduate Research Assistant Research Assistant Professor Chair Professor 4) Assistant Professor

Finite Element Model Updating in the Vibration of Bladed Disk: Shaft Assemblies

Model Updating for Disk-Rod-fastening Rotor Based on DOE

Finite element model updating of machine-tool spindle systems

Analyse Rotor Dynamics of Agitating Shaft with the Finite Element Method

Reduced Order Modeling and Vibration Analysis of Mistuned Bladed Disk Assemblies With Shrouds

Finite Element Model Updating using Acceleration and Angular Velocity *Hyun-jun

Updating Finite Element Model of a Wind Turbine Blade Section Using Experimental Modal Analysis Results

A COUPLED VIBRATION ANALYSIS METHOD OF BLADED DISK MODELBASED ON EQUIVALENT BLADE GROUP OF ANNULAR PLATE WITH VARIABLE PARAMETERS

The Composite Methods of Updating Finite Element Models

Nonlinear finite element model updating with a decentralized approach

Finite element model updating method and its application

Experimental updating of a segmented wind turbine blade numerical model using the substructure method

Validation of a finite-element model of a wind turbine blade bearing

A Reduced Order Approach for the Vibration of Mistuned Bladed Disk Assemblies

Determination of Contact Stiffness and Damping of a Tie-Bolt Rotor with Interference Fits Using Model Updating with Thin-Layer Elements

Combinatorial Optimization of Mistuned Blade Rearrangement Based on Reduced-Order FEA Model

Model Updating In Structural Dynamics: A Survey

AN EQUIVALENT MODELING METHOD BY SIMPLIFYING BLADE GROUP TO AN ANNULAR PLATE WITH VARIABLE PARAMETERS

Numerical Analysis of Rotating Flexible Blade-Disk-Shaft Systems

Structural Finite Element Model Updating by Using Response Surfaces and Radial Basis Functions