Abstract:C/Cx-SiCy composites are one of the most promising counterparts of C/C composites as they maintain the mechanical strength of C/C composites while providing excellent anti-ablation properties at the same time. This paper reports that the composites could exhibit even better anti ablation properties after heat treatment. The materials were heat-treated and then tested with a thin-blade oxyacetylene torch without the protection of any coatings. The 1600 °C heat-treated thin-blade specimen could sustain the ablation of the oxyacetylene torch with a temperature of 1776 °C (80 °C higher than the original material without heat treatment) and a lower liner ablation rate (1.31 μm/s) than the original material (1.66 μm/s). An extreme ablation test was also conducted at around 2400 °C, and the 1600 °C heat-treated specimen exhibited a lower linear ablation rate (13 μm/s) than the original specimen (47 μm/s). The influence of the heat treatment on the crystallinity of the matrix is studied with the additional help of Raman spectroscopy and XPS. The ablation mechanism is discussed in detail, and the fluent condition of the thin-blade specimen is simulated. The paper also reports a different ablation behavior of the 1600 °C heat-treated specimen from the material without heat treatment to explain their excellent ablation property.

Ablation mechanism of SiC coated C/C composites at 0° angle in two flame conditions under an oxyacetylene flame

Ablation Mechanism of AlSiB-C/C Composites under an Oxy-Acetylene Torch

Ablation mechanism and properties of SiCf/SiBCN ceramic composites under an oxyacetylene torch environment

Ablation behavior and mechanisms of ZrC-SiC-MoSi2 coated C/C-SiC-ZrC ceramic matrix composites under oxyacetylene torch

Ablation behavior of thin-blade co-deposited C/Cx-SiCy composites under the influence of the complex fluid conditions of the oxyacetylene torch

Ablation behavior of sharp leading-edge C/C-ZrC-SiC composites using 3000 C oxyacetylene torch

Cyclic ablation behavior of C/C–ZrC–SiC composites under oxyacetylene torch

Ablation behaviour of the CVD-(ZrC/SiC)3 alternate coating on C/C composites under oxyacetylene torch with different heat fluxes

Microstructure and ablation mechanism of graphite/SiC composites under oxy-acetylene flame

Ceramic Matrix Composite Cyclic Ablation Behavior under Oxyacetylene Torch

Ablation performance of C/C-ZrC-SiC composites with in-situ YSi 2 -doped ZrC-SiC-ZrSi 2 coating under oxyacetylene torch

Ablation behavior of C/C–Zr1-xHfxC-SiC composites under an oxyacetylene flame at above 2500 °C

Ablation behavior of Cf/ZrC-SiC and Cf/SiC composites produced by precursor infiltration and pyrolysis combined with gaseous silicon infiltration

The influence of heat treatment on the ablation behavior of the C/Cx-SiCy composites tested by thin-blade under oxyacetylene torch

Ablation behavior of C f /ZrC–SiC ultra–high temperature ceramic composites in oxyacetylene torch and plasma wind tunnel

Ablation properties and mechanisms of BN-coated Cf-reinforced SiBCNZr ceramic composites under an oxyacetylene combustion torch

Comparison of the ablation resistance of mullite modified C/C-SiC-HfC and C/C-SiC-HfC composites under oxyacetylene flame of 2.38 MW/m 2 heat flux

Ablation behavior of mullite modified C/C-SiC-HfC composites under oxyacetylene torch for single and cyclic ablations with two heat fluxes

Cyclic Ablation Properties of C/SiC-ZrC Composites

Ablation and mechanical behaviour of C/C composites under an oxyacetylene flame and tensile loading environment

Cyclic ablation behavior of mullite-modified C/C-HfC-SiC composites under an oxyacetylene flame at about 2400 °C