Abstract:In this work, we propose a simple and efficient interfacial modification method for thin-film transistor (TFT)-1 with poor stability under bias stress. For conventional top-contact TFT-2, the sputtering passivation layer will cause the device to be in a short-circuit condition. We used inverted coplanar-structured TFT-3 to separate the high conductivity layer from the S/D electrodes to avoid the short-circuit failure of the device, but this will cause a hump effect. Ultraviolet treatment and air annealing were performed on TFT-3 simultaneously to obtain TFT-4 with high mobility (μsat = 45.5 cm2 V–1 s–1), steep subthreshold swing (SS = 86 mV/dec), and good bias stability (±20 V, 3600 s, NBS: −0.1 V, PBS: +0.9 V, PGDBS: +0.5 V). The forward and reverse tests of TFT-1 and TFT-4 after the PGDBS test show that TFT-4 has a good stability of the asymmetric electrical bias. Finally, XRR, XPS, AFM, and contact angle were tested to further investigate the material mechanisms. In this paper, we show that the interfacial passivation of TFT can effectively isolate the invasion of external water/oxygen and compensate for interfacial defects and dangling bonds. The decomposition and rearrangement of the oxide are induced by UV + thermal annealing, which optimizes the stacking pattern of the cells, effectively reducing the defect states and eliminating parasitic channels and the hump phenomenon. Finally, an amorphous oxide semiconductor (AOS)-TFT instrument with high mobility and good stability is prepared. The method in this paper addresses the problem that the passivation layer cannot be prepared by sputtering, which is a cost-effective process.

Reduction of the Interfacial Trap Density of Indium-Oxide Thin Film Transistors by Incorporation of Hafnium and Annealing Process

High bias stability of Hf-doping-modulated indium oxide thin-film transistors

Improved Environmental Stability of InSnO Thin-Film Transistor by Interface Engineering

The Hump Phenomenon and Instability of Oxide TFT Were Eliminated by Interfacial Passivation and UV + Thermal Annealing Treatment

Stability enhancement of top-gate self-aligned tin-doped indium gallium oxide thin film transistor by low temperature annealing

High Mobility Thin-Film Transistor with Solution-Processed Hafnium-Oxide Dielectric and Zinc-Indium-Tin-Oxide Semiconductor

Optimizing Photonic Annealing Technique for High-k Dielectric of Full-Solution-Processed Oxide Thin Film Transistor

Simultaneous Enhancement of Electrical Performance and Negative Bias Illumination Stability for Low-Temperature Solution-Processed SnO2 Thin-Film Transistors by Fluorine Incorporation

High-performance a-ITZO TFTs with high bias stability enabled by self-aligned passivation using a-GaOx

Significant Performance and Stability Improvements of Low-Temperature IGZO TFTs by the Formation of In-F Nanoparticles on an SiO2 Buffer Layer

Solution-processed Coplanar Top-Gate ZnInSnO Thin Film Transistors and Bias Stability

High-mobility hydrogenated polycrystalline In2O3 (In2O3:H) thin-film transistors

Effects of Annealing Temperature on Bias Temperature Stress Stabilities of Bottom-Gate Coplanar In-Ga-Zn-O Thin-Film Transistors

Enhanced NBIS Stability of Oxide Thin-Film Transistors by Using Terbium-Incorporated Alumina

P‐1.1: Co‐sputtering‐deposited Hf‐doped ITO Thin Films for Thin Film Transistors Application

High Performance (vth ~ 0 V, SS ~ 69 Mv/dec, IOn/IOff ~ 1010) Thin-Film Transistors Using Ultrathin Indium Oxide Channel and SiO2 Passivation

Performance Enhancement of InGaZnO Top-Gate Thin Film Transistor With Low-Temperature High-Pressure Fluorine Treatment

Bias Stress Stability of Solution-Processed Nano Indium Oxide Thin Film Transistor

Low-temperature fabrication of high performance indium oxide thin film transistors

Effect of Indium Doping on Bias Stability in Dual-Target Co-Sputtering InZnSnO Thin-Film Transistors

Thermal Annealing Improved Stability of Amorphous InGaZnO Thin-Film Transistors Under AC Bias Stresses