Abstract:The crack tip constraint effect should be considered in the fracture assessment of structures with cracks, and the in-plane constraint and out-of-plane constraint should be illustrated simultaneously for the three-dimensional cracks in practical engineering structures. The constraint effect of central cracked plate (CCP) specimens with I-II mixed mode crack under uniaxial compression has been investigated quantitatively in present work. The relationship between T-stress components (Tx, Ty, Txy) and in-plane constraint parameter T11 has been established. The effects of a wide range of in-plane and out-of-plane geometrical configurations (including relative crack length a/W and thickness to width ratio t/W), material parameters (including elastic modulus E and Poisson's ratio ν), crack inclination angle β and friction coefficient μ corresponding to stress intensity factors (K), in-plane constraint parameter T11 and out-of-plane constraint parameters T33 and Tz at the crack tip have been calculated and discussed theoretically and numerically. It demonstrates that the constraint parameters can effectively express the stress-strain field at the crack tip. The relative crack length a/W has an influence on the in-plane and out-of-plane constraint parameters, and the thickness to width ratio t/W mainly affects the out-of-plane constraint parameters T33 and Tz. The out-of-plane constraint parameters should be considered for long cracks. There is a loss of out-of-plane constraint under compression when t/W less than or equal to 0.9, which can be much more directly and evidently investigated through the analysis of Tz than T33. The empirical equations for KII, T11 and Tz have been obtained according to theoretical analysis and simulation results, which are convenient and effective for application.

Characterization and correlation of 3-D creep constraint between axially cracked pipelines and test specimens

Characterization of creep constraint effect for brazed joint specimens at crack tip by new constraint parameter A

A new creep-fatigue crack growth model and a correlation of the creep-fatigue crack growth rate with unified constraint parameter

Load-independent creep constraint analysis and solutions for surface cracks in pressurized pipes

Creep Behaviors Calculated by Varying Material Constants Obtained from Different Stress Regions for a Closed-End P91 Pipe

3D front tip fields in creeping solids under constraint effects: a higher-order asymptotic solution

A Creep Constitutive Model, Based on Deformation Mechanisms and Its Application to Creep Crack Growth

Effect of constraint on creep fracture toughness of a Cr-Mo-V steel

Characterization of Mismatch Constraint Effect for the Central Crack Plate under Biaxial Loading

Study of Strain Capacity for High-Strain Marine Pipe

Characterizations of Material Constraint Effect for Creep Crack in Center Weldment under Biaxial Loading

Constraint modified time dependent failure assessment diagram (TDFAD) based on <i>C</i>(<i>t</i>)-<i>A</i><sub>2</sub>(<i>t</i>) theory for creep crack

A Higher-Order Asymptotic Solution for 3d Sharp V-Notch Front Tip Fields in Creeping Solids

T-stresses solution and out-of-plane constraint for central cracked plate (CCP) with I-II mixed mode crack under uniaxial compression

Creep Rupture Assessment of Cyclically Heated 3D Pressure Pipelines with Volumetric Defects Using a Direct Numerical Approach

Creep crack growth prediction using a damage based approach

Effect and mechanism of constraint on creep crack growth behavior of GH3535 alloy

Mismatch Constraint Effect for Bimaterial Interfacial Creep Crack

Creep fracture parameter C* solutions for semi‐elliptical surface cracks in plates under tensile and bending loads

Novel semi-analytical model for solving the C *-integral of specimens with mode-I crack under various constraints

The Interacting Effect for Collinear Cracks Near Mismatching Bimaterial Interface under Elastic Creep