Abstract:The accurate assessment of creep–fatigue interaction is an important issue for industrial components operating with large cyclic thermal and mechanical loads. An extensive review of different aspects of creep fatigue interaction is proposed in this paper. The introduction of a high temperature creep dwell within the loading cycle has relevant impact on the structural behavior. Different mechanisms can occur, including the cyclically enhanced creep, the creep enhanced plasticity and creep ratchetting due to the creep fatigue interaction. A series of crucial parameters for crack initiation assessment can be identified, such as the start of dwell stress, the creep strain, and the total strain range. A comparison between the ASME NH and R5 is proposed, and the principal differences in calculating the aforementioned parameters are outlined. The linear matching method (LMM) framework is also presented and reviewed, as a direct method capable of calculating these parameters and assessing also the steady state cycle response due to creep and cyclic plasticity interaction. Two numerical examples are presented, the first one is a cruciform weldment subjected to cyclic bending moment and uniform high temperature with different dwell times. The second numerical example considers creep fatigue response on a long fiber reinforced metal matrix composite (MMC), which is subjected to a cycling uniform thermal field and a constant transverse mechanical load. All the results demonstrate that the LMM is capable of providing accurate solutions, and also relaxing the conservatisms of the design codes. Furthermore, as a direct method, it is more efficient than standard inelastic incremental finite element analysis.

Mismatch Constraint Effect for Bimaterial Interfacial Creep Crack

Mismatch Constraint Effect of Creep Crack With Modified Boundary Layer Model

Influences of material mismatch on interface crack tip field in three layered creeping materials

Characterizations of Material Constraint Effect for Creep Crack in Center Weldment under Biaxial Loading

Characterization of Mismatch Constraint Effect for the Central Crack Plate under Biaxial Loading

The Interacting Effect for Collinear Cracks Near Mismatching Bimaterial Interface under Elastic Creep

Influences of T-Stress on Constraint Effect in Mismatched Modified Boundary Layer Model for Creep Crack

Dai, Yanwei and Liu, Yinghua and Chen, Haofeng (2016) Influences of T- stress on constraint effect in mismatched modified boundary layer model for creep crack. In: ASME 2016 Pressure Vessels and Piping

Characteristics and Implications of Material Mismatch on Mode II Creep Crack Tip Field: Theoretical Analysis and Numerical Investigation

Mismatch Effect on the Mode II Type Crack Tip Field in Power-Law Creeping Materials

Effect of Weld Interface on Time-dependent Fracture Mechanics Parameters

Effect of constraint on creep fracture toughness of a Cr-Mo-V steel

Research on Fatigue-Creep Interaction Damage of Steel 1.25Cr0.5mo

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

On Creep Fatigue Interaction of Components at Elevated Temperature

A new creep-fatigue crack growth model and a correlation of the creep-fatigue crack growth rate with unified constraint parameter

Effect of Mechanical Heterogeneity on Strain and Stress Fields at Crack Tips of SCC in Dissimilar Metal Welded Joints

Characterization of creep constraint effect for brazed joint specimens at crack tip by new constraint parameter A

Numerical Investigations on the Effects of T-Stress in Mode I Creep Crack

Effect of Inhomogeneous Mechanical Properties on the Stress-Strain Field at the Crack Tip and Crack Growth Direction in Dissimilar Metal Welded Joints

Constraint modified time dependent failure assessment diagram (TDFAD) based on <i>C</i>(<i>t</i>)-<i>A</i><sub>2</sub>(<i>t</i>) theory for creep crack